Hubbardton Forge 205305 User Manual

Installation Instructions B232

Callas Sconce 20-5305 Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

After installation extra hardware and accessories are possible due to our kits are used on multiple products and options.

To Mount Fixture to Wall (Figure 1)

Component Parts

A Fixture
B Crossbar
C Threaded Stud (2)
D Knurl Ball (2)
E Ground Screw

Caution: Be sure power is off at the main breaker box prior to installation.

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not

provided), fasten the crossbar (B) to
the electric box making sure that
fixture mounting holes are level.

Note: A new electric box comes
with screws. When replacing a
fixture, retain the existing screws for
use with the new fixture.

3. Thread studs (C) into the

appropriate holes in the crossbar
(B). Adjust the studs to proper
length to ensure the fixture will fit
snugly to the wall.

4. Hold the fixture (A) close to the

wall and using suitable wire
connectors (not provided) connect
fixture wires to supply (white to
white or ribbed and black to black
or smooth). Run a pigtail lead from
crossbar ground screw (E) to the
junction box and connect all ground
wires (bare copper or green to bare
copper or green).

Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.

5. Slide fixture (A) over threaded studs (C) and push firmly to wall, making sure that no wires are pinched between

fixture and wall. Fasten with knurl balls (D). Be sure threaded studs (C) are fully seated in the knurl balls (D).

6. See instructions following to complete installation.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

(Figure 1)

continued)

(

26934

Installation Instructions B232

Callas Sconce 20-5305 Page 2 of 2

To Install Bulb and Glass Shield (Figure 2)

Component Parts

F Bulb
G Glass Shield
H Socket

1. Install light bulb (L). Be careful not to touch bulb with bare hands; oil from the hands will dramatically reduce

bulb life.

Note: The bulb included is based on our design preference; see the fixtures wattage sticker for Max wattage
information.

2. Thread glass shield (G) onto socket (H).

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

(Figure 2)

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

26934