Hubbardton Forge 205105 User Manual

Glass Installation Instructions B22

Page 1 of 2

Your new lighting fixture has been shipped with the glass installed. It may be necessary to remove the glass when
installing the fixture.

To Remove Glass

1. Remove the knurled balls at the sides of the glass.

2. Remove the leaf assembly and glass from the screws. Remove one side at a time.

To Install Glass

Note: The bracket is slightly bent toward the wall. This provides tension in the bracket, which holds the glass securely to
the wall. The amount of tension may be adjusted by bending the bracket slightly as needed.

1. Place the hooked portion of the leaf

assembly over the front edge of the glass so
the curled ends of the leaf assembly line up
with the holes in the side of the glass.

2. Gently pull one side of the bracket away

from the wall and slide one side of the glass
and leaf assembly over the screw.

3. Attach the other side in the same manner

using a rocking motion. It is not possible to
attach both sides simultaneously.

4. Secure the glass and leaf assembly using the

knurled balls.

5. Adjust the glass to level by turning the two

adjusting screws as needed.

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

14045

Installation Instructions B11

For Direct Wire Wall Mounted Fixtures – B Page 2 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

For fixtures requiring assembly, please refer to assembly instructions before installation.

Component Parts

A Two Machine Screws
B Green Ground Screws
C Crossbar
D Box Machine Screws

To Install

Caution: Be sure power is off at the main breaker box prior to installation.

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (D, not provided), fasten the

crossbar (C) to the electric box (see illustration), making sure
that fixture mounting holes are level.

Note: A new electric box comes with screws. When replacing
a fixture, retain the existing screws for use with the new
fixture.

4. Using suitable wire connectors (not provided) connect fixture

wires to supply wires (white to white (G) and black to black
(E)). If the fixture is wired with twin lead lamp cord, connect
white to ribbed side of the fixtures cord, black to smooth side.
Connect all ground wires (F) to crossbar ground screw (B).

Caution: Make sure wire connectors are twisted on securely,
and no bare wire is exposed.

5. Place fixture firmly against wall and fasten with two machine

screws (A).

6. Install light bulb(s) (not provided).

7. Restore electricity at main breaker.

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

E Black Wire
F Ground Wire
G White Wire

This illustration represents a typical
fixture and may not match every style.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

14045