Hubbardton Forge 204790 User Manual

Installation Instructions B198

For Sconce 20-4790 Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

To Mount Fixture to Wall (Figure 1)

Component Parts

A Crossbar
B 8-32 Screws (2)
C Cupped Washer
D Ground Screw

Caution: Be sure power is off at the main breaker box prior to installation.

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided),

fasten the crossbar (A) to the electric box
making sure that fixture mounting holes are
level.

Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.

3. Hold the fixture close to the wall and using

suitable wire connectors, not provided, connect
fixture wires to supply (white to white or ribbed
and black to black or smooth). Ground using the
green ground screw (D) and cupped washer (C)
to secure a pigtail lead to the crossbar (A).

Caution: Make sure wire connectors are
twisted on securely, and no bare wire is
exposed.

4. Carefully tuck all wires behind the fixture, place

fixture firmly against the wall and fasten with
two 8-32 screws (B).

5. See instructions following to install bulb and

glass.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

(Figure 1)

(continued)

23985

Installation Instructions B198

For Sconce 20-4790 Page 2 of 2

To Install Glass

Component Parts

E Socket
F Bulb (Included)
G Glass
H Glass Spring Clip
I Wireway
J Forged Front Plate

1. Install light bulb (F). Be careful not to touch bulb with bare hands; oil

from the hands will dramatically reduce bulb life.

2. Slip glass (G) with slot pointing down through forged front plate until

it engages with glass spring clip (H).

3. Pull glass (G) slightly forward to clear bottom of the forged plate.

Align slot in glass (G) so it slips onto wireway (I).

4. Restore electricity at main breaker.

(Figure 2)

(Figure 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

23985