Hubbardton Forge 204350 User Manual
Installation Instructions B288
CAUTION: FAILURE TO INSTALL THI S FIXTURE PROPERLY MAY RESULT I N SERIO US PERSO NAL
(Figure 1)
Hobie Sconce 20-4350 Page 1 of 2
INJURY OR DEATH AND PROPERTY DAMAGE. We rec o mm e nd installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Fixture Assembly
B Wall Mounting Bracket
C #8 Black Screws (4)
D Green Ground Screw
E Cupped Washer
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided),
fasten the wall mounting bracket (B) to the
electric box making sure that fixture
mounting holes are level.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.
3. Thread the wires in the electrical box through
the center hole in the wall mount bracket.
4. Hold the fixture assembly (A) close to the
wall mount bracket (B) and, using suitable
wire connectors (not provided), connect
fixture wires to supply wires (white to white
or ribbed and black to black or smooth). Run
a pigtail lead from the green ground screw
(D) and cupped washer (E) and connect all
ground wires (bare copper or green to bare
copper or green).
Caution: Make sure wire connectors are
twisted on securely, and no bare wires are
exposed.
5. Carefully tuck all wires behind the fixture
assembly and inside the wall mount bracket and
place the fixture firmly onto mounting brack et (B)
and fasten with (2) #8 black screws on top (C).
6. To complete attachment of fixture, install remaining black screws (C) in bottom of fixture.
7. Complete steps below to install bulb and glass.
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
28113
(continued)
Installation Instructions B288
(Figure 2)
Hobie Sconce 20-4350 Page 2 of 2
To Install Bulb & Glass Shield (Figure 2)
Component Parts
A Fixture Assembly
F Socket
G Bulb
H Glass Shield
1. Install bulb (G) (included). Be careful not to touch bulb with bare
hands; oil from the hands will dramatically reduce bulb life.
2. Thread glass shield (H) onto socket (F) until snug. Be sure not to
over tighten.
3. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
*
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
28113
Loading...