Page 1
Installation Instructions B32
For One Light Wall Sconce 20-4012 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
After installation extra hardware and accessories are possible; our kits are used on multiple products and options.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Fixture
B Screw Cap
C Nipple
D Lock Nut
E Crossbar
F Ground Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided)
attach cross bar (E) to the electric box.
Note: A new electric box comes with
screws. When replacing a fixture, retain the
screws for use with the new fixture.
3. Thread the nipple (C) into the crossbar and
secure with lock nut (D). Adjust the nipple
to proper length to ensure the fixture will fit
snugly to the wall.
4. Using suitable wire connectors (not
provided), connect the fixture wires to the
supply wires, (white to white, black to
black, bare copper or green to bare copper
or green). Ground the crossbar using the
green ground screw (F) to secure a pigtail
lead to the bracket.
If the fixture is wired with twin lead lamp
cord, connect the ribbed side to white, and
the smooth side to black.
Caution: Make sure wire connectors are
twisted on securely and no bare wires are exposed.
5. Carefully tuck all wires behind the fixture, place fixture
firmly against the wall and fasten screw cap (B).
6. See instructions following to install bulb and glass.
Figure 1
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
(continued)
15020 Rev A
Page 2
Installation Instructions B32
For One Light Wall Sconce 20-4012 Page 2 of 2
To Install Glass
Component Parts
G Glass
H Socket
I Retaining Ring
J Bulb Shield
K Bulb
L Socket Tool
(Figure 2)
1. Remove retaining ring (I) from socket (H).
2. Slip glass (G) over socket (H).
3. Thread retainer ring (I) onto socket (H) until snug against
bottom of glass (G). Be careful not to over tighten
4. Install light bulb (K). Be careful not to touch bulb with bare
hands; oil from the hands will dramatically reduce bulb life.
5. Thread bulb shield (J) onto socket (H) (be careful not to over
tighten). Future bulb changes may be accomplished by
snapping glass portion of barrier on and off rather than
unthreading the holder.
6. Restore electricity at main breaker.
Figure 2
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
15020 Rev A
Loading...