Page 1
Installation Instructions B181
For Ribbon Double Glass Wall Sconce 20-4104 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Fixture Assembly
B Screw Cap
C Threaded Nipple
D Lock Nut
E Crossbar
To Install
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided) attach
crossbar (E) to the electric box.
Note: A new electric box comes with screws. When
replacing a fixture, retain the screws for use with
the new fixture.
3. Thread the nipple (C) into the crossbar (E) and
secure with lock nut (D). Adjust the nipple to
proper length to ensure the fixture will fit snugly to
the wall.
4. Using suitable wire connectors (not provided),
connect the fixture wires to the supply wires, (white
to white, black to black, bare copper or green to
bare copper or green). If the fixture is wired with
twin lead lamp cord, connect the ribbed side to
white, and the smooth side to black.
Caution: Make sure wire connectors are twisted
on securely and no bare wires are exposed.
5. Carefully tuck all wires behind the fixture, place
fixture firmly against the wall and fasten screw cap (B).
(Figure 1)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
(continued)
22767
Page 2
Installation Instructions B181
For Ribbon Double Glass Wall Sconce 20-4104 Page 2 of 2
To Install Glass
Component Parts
F Socket
G Bulb (included)
H Retaining Ring (2)
I Inner Glass
J Outer Glass
K Socket Tool
L Spacer
(Figure 2)
1. Remove retaining rings (H) from socket (F). Retaining rings are shipped
installed.
2. Install light bulb (G). Be careful not to touch bulb with bare hands; oil from
the hands will dramatically reduce bulb life.
3. Slip outer glass (J) and spacer (L) (oriented as shown in figure 2) over
socket (F) and thread one of the retaining rings onto the socket (F) using
provided socket tool (K). Note: Flat side of retaining ring should be
oriented as shown.
4. Slip inner glass (I) over socket (F).
5. Thread retaining ring (H) onto socket (F) using provided socket tool (K)
until snug against inner glass (I). Be careful not to over tighten. Note: Flat
side of retaining ring should be oriented as shown.
6. Restore electricity at the main breaker.
(Figure 2)
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
22767
Loading...