Hubbardton Forge 204050F User Manual

Installation Instructions B148

For Berceau Sconce 20-4050F Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

To Mount Fixture to Wall (Figure 1)

Component Parts

A Crossbar
B Threaded Stud (2)
C Barrel Knob (2)
D Fixture Assembly
E Ground Screw

Caution: Be sure power is off at the main breaker box prior to installation.

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided), fasten the

crossbar (A) to the electric box making sure that fixture
mounting holes are level.

Note: A new electric box comes with screws. When
replacing a fixture, retain the existing screws for use
with the new fixture.

3. Thread studs (B) into the appropriate holes in the crossbar

(A). Adjust the studs to proper length to ensure the fixture
will fit snugly to the wall.

4. Hold the fixture assembly (D) close to the wall and using

suitable wire connectors (not provided) connect fixture
wires to supply (white to white or ribbed and black to black
or smooth). Connect all ground wires to ground screw.

Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.

5. Slide fixture assembly (D) over threaded studs (B) and push

firmly to wall, making sure that no wires are pinched
between fixture back and wall. Fasten with barrel knobs
(C). Be sure threaded studs (B) are fully seated in the
barrel knobs (C).

6. See instructions on next page to install glass.

(Figure 1)

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

21274

Installation Instructions B148

For Berceau Sconce 20-4050F Page 2 of 2

To Install Glass

Component Parts

F Retaining Ring
G Glass
H Socket
I Socket Tool

1. Remove retaining ring (F) from socket (H). Retaining Rings are

shipped installed.

2. Place glass (G) over socket (H).

3. Replace retaining ring (F) and tighten with tool (I) to secure glass.

Do not over-tighten.

4. Install light bulb. Included with fixture.

5. Restore electricity at the main breaker.

(Figure 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

(Figure 2)

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

21274