Hubbardton Forge 204050 User Manual

Installation Instructions B147

For Berceau Sconce 20-4050 Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

For fixtures requiring assembly, please refer to assembly instructions before installation.

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

To Mount Fixture to Wall (Figure 1)

Component Parts

A Crossbar
B Threaded Stud (2)
C Barrel Knob (2)
D Fixture Assembly
E Ground Screw

Caution: Be sure power is off at the main breaker box
prior to installation.

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided), fasten

the crossbar (A) to the electric box making sure that
fixture mounting holes are level.

Note: A new electric box comes with screws.
When replacing a fixture, retain the existing screws
for use with the new fixture.

3. Thread studs (B) into the appropriate holes in the

(Figure 1)

crossbar (A). Adjust the studs to proper length to
ensure the fixture will fit snugly to the wall.

4. Hold the fixture assembly (D) close to the wall and using suitable wire connectors, not provided, connect fixture

wires to supply (white to white or ribbed and black to black or smooth). Connect all ground wires to ground
screw.

Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.

5. Slide fixture assembly (D) over threaded studs (B) and push firmly to wall, making sure that no wires are pinched

between fixture back and wall. Fasten with barrel knobs (C). Be sure threaded studs (B) are fully seated in the
barrel knobs (C).

6. See instructions on next page to install glass.

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

21273

Installation Instructions B147

For Berceau Sconce 20-4050 Page 2 of 2

To Install Glass

Component Parts

F Retaining Ring
G Washer
H Glass
I Socket
J Socket Tool

(Figure 2)

1. Remove retaining ring (F) from socket (I). Retaining Rings are shipped

installed.

2. Place glass (H) over socket (I).

3. Place washer (G) over socket (I) until it rests on the bottom inside of

glass (H).

4. Replace retaining ring (F) and tighten with socket tool (J) to secure

glass. Do not over-tighten.

5. Install light bulb.

6. Restore electricity at the main breaker.

(Figure 2)

This illustration represents a typical

fixture and may not match every style.

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

21273