Page 1
Installation Instructions A223
CAUTION: FAILURE TO INSTALL THI S FIXTURE PROPERLY MAY RESULT I N SERIO US PERSO NAL
(Figure 1)
Simple Sweep Chandelier 10-1150, 10-1160 & 19-104315LC Page 1 of 1
INJURY OR DEATH AND PROPERTY DAMAGE. We rec o mm e nd installation by a li cens ed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
To Install the Canopy (Figure 1)
Component Parts
A Ground Screw
B Crossbar
C Lock Nut
D Nipple
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar (B) to the
electric box (see illustration).
Note: A new electric box comes with screws. When replacing a fixture, retain
the existing screws for use with the new fixture.
3. Thread the nipple (D) into the crossbar (B) and secure with lock nut (C); slide
canopy (E) over nipple (D), and attach the canopy loop (F) to the nipple (D).
Adjust the nipple to proper length to ensure a snug canopy fit before
proceeding.
4. Attach one end of the chain to the fixture loop (H). Lace the wire through
every other link of the chain to the end. Slip wires and chain through the
collars and canopy (G, F & E). Fasten the chain to the canopy loop (F) then
slip wires through the loop and nipple into the electric box. Make sure to
provide enough slack in the wire to ensure weight of fixture is supported by
the chain.
5. Using suitable wire connectors (not provided) connect fixture wires to supply
wires (white to ribbed side of the fixture cord, black to smooth side). Run a
pigtail lead from crossbar ground screw (A) to the junction box and connect
all ground wires (bare copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no bare
wire is exposed.
6. Raise canopy (E) to the ceiling and secure loop collar (G) to canopy loop (F).
E Canopy
F Cano p y Loop
G Loop Collar
H Fixture Loop
If you need further assistance, or find that you are missing any parts, please
contact the dealer from which you purchased th is product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
23183 Rev A
Loading...