Hubbardton Forge 126754 User Manual

Installation Instructions A49

g

For Semi Flush Pendants with Twist Locking Mechanism Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum watta

For fixtures requiring assembly, please refer to assembly instructions prior to installation.

e noted on fixture. Use only recommended bulbs with fixture.

To Install

Component Parts

A Canopy
B Electric Box Machine Screws (not provided)
C Black or Smooth Wires
D Ground Wires
E White or Ribbed Wires

(Figure 1)

F Round Cross Bar
G 8-32 Threaded Studs
H 8-32 Knurled Balls
I Wire Nuts or connectors (not provided)
J Green Ground Screw

Caution: Be sure power is off at the main breaker box prior to installation

1. Carefully unpack the fixture from the carton.

2. Thread studs (G) through appropriate holes in cross bar (F) to match

hole centers in canopy (A). Move ground screw (J) to another
available threaded hole if necessary.

3. Using two machine screws (B, not provided) fasten cross bar to the

electric box using outer oval holes to orient fixture to desired
hanging position.

Note: A new electric box comes with screws. When replacing an
existing fixture, retain the screws for use with the new fixture.

4. Using suitable wire connectors (I) (not provided), connect fixture

wires to supply wires (white to white or ribbed (E) and black to
black or smooth (C). Connect all ground wires (D) to green ground
screw (J).

Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.

5. Slide fixture canopy (A) over threaded studs and push firmly to

ceiling, making sure that no wires are pinched between fixture
canopy and ceiling. Fasten with knurled balls (H). Be sure studs (G)

Figure 1

are fully seated in the knurled balls (H).

6. Install light bulb(s) (not provided).

7. Install glass (refer to glass installation instructions if appropriate).

8. Restore electricity at main breaker.

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 15636 Rev A

Installation Instructions A49

For Semi Flush Pendants with Twist Locking Mechanism Page 2 of 2

To Install Glass (Figures 2 & 3)

Component Parts

K Bands (3)
L Glass
M Screws (3)
N Hooks (3)

1. Attach bands (K) to glass (L) by placing band sections around lip of glass and securing with countersunk

screws (M) (Figure 2).

Note: One hole is threaded and the other is not. Screws must go through the unthreaded hole then into the
threaded hole.

2. To attach glass to fixture, position glass around sockets and place the loops of the bands (K) over the hooks (N)

on the fixture (Figure 3).

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Figure 2

Figure 3

Hand-Forged, Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 15636 Rev A