Hubbardton Forge 126753F User Manual

Assembly & Installation Instructions A141

For Impressions Semi-Flush 12-6750F & 12-6753F Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

To Install Fixture (Figure 1)

Component Parts

A Ground Screw
B Cross Bar
C Threaded Stud (3)
D Canopy
E Barrel Knobs (3)

Caution: Be sure power is off at the main breaker box prior to installation

1. Carefully unpack the fixture from the carton.

2. Thread studs (C) through appropriate holes in cross bar (B) to match

hole centers in canopy (D). Move ground screw (A) to another available
threaded hole if necessary.

3. Using two machine screws (not provided) fasten cross bar (B) to the

electric box using outer oval holes to orient fixture to desired hanging
position.

Note: A new electric box comes with screws. When replacing an existing
fixture, retain the screws for use with the new fixture.

5. Using suitable wire connectors (not provided); connect fixture wires to

supply wires (white to white and black to black). Connect all ground wires to green ground screw (A).

Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.

6. Slide fixture canopy (D) over threaded studs and push firmly to ceiling, making sure that no wires are pinched

between fixture canopy and ceiling. Fasten with barrel knobs (E). Be sure studs (C) are fully seated in barrel
knobs (E).

(Figure 1)

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

(continued)

21150

Assembly & Installation Instructions A141

For Impressions Semi-Flush 12-6750F & 12-6753F Page 2 of 2

To Install Glass (Figure 2)

Component Parts

F Socket
G Bulb
H Glass
I Spider Assembly
J Retaining Ring
K Diffuser

1. Place glass (H) into notches of spider assembly (I).

2. Lift glass (H) and spider assembly (I) over socket (F) until it stops.

3. Thread retaining ring (J) on to socket (F) until it rests against the bottom of

the spider assembly (I).

4. Install light bulb (G).

5. Insert the diffuser (K) up into the fixture at an angle then level it and gently

lower onto the lowest tabs of the spider assembly (I).

(Figure 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

21150