Page 1
Installation Instructions A280
For Semi-Flush 12-6745 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
To Install Fixture (Figure 1)
Component Parts
A Canopy
B Cross Bar
C Threaded Stud (2)
D Knurled Balls (2)
E Ground Screw
Caution: Be sure power is off
at the main breaker box prior
to installation
1. Thread studs (C) through
appropriate holes in cross
bar (B) to match hole
centers in canopy (A).
Move ground screw (E)
to another available
threaded hole if
necessary.
2. Using two machine
screws (not provided)
fasten cross bar (B) to the
electric box using outer
oval holes to orient
fixture to desired hanging
position.
Note: A new electric box
comes with screws.
When replacing an
existing fixture, retain the
screws for use with the
new fixture.
3. Using suitable wire
connectors (not
provided); connect
fixture wires to supply
wires (white to white and black to black). Run a pigtail lead from crossbar ground screw (E) to the function box
and connect all ground wires (Bare copper or green to bare copper or green).
are twisted on securely, and no bare wire is exposed.
4. Slide fixture canopy (A) over threaded studs and push firmly to ceiling, making sure that no wires are pinched
between fixture canopy and ceiling. Fasten with knurled balls (D). Be sure studs (C) are fully seated in knurled
balls (D).
(Figure 1)
Caution: Make sure wire connectors
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
26649
Page 2
Installation Instructions A280
For Semi-Flush 12-6745 Page 2 of 2
To Install Glass (Figure 2)
Component Parts
A Canopy
F Glass
G Ball Head Screws (3)
1. Install light bulbs. (Not Included)
2. Raise glass (F) into canopy (A).
3. Install (3) Ball Head Screws (G) and tighten to secure glass. Be sure not to over tighten.
4. Restore electricity at main breaker.
(Figure 2)
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
26649
Loading...