Page 1
Installation Instructions A278
For Semi-Flush 12-6740 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
To Install Fixture (Figure 1)
Component Parts
A Canopy
B Cross Bar
C Threaded Stud (2)
D Knurled Balls (2)
E Ground Screw
Caution: Be sure power is off at the main
breaker box prior to installation
1. Thread studs (C) through appropriate
holes in cross bar (B) to match hole
centers in canopy (A). Move ground
screw (E) to another available threaded
hole if necessary.
2. Using two machine screws (not
provided) fasten cross bar (B) to the
electric box using outer oval holes to
orient fixture to desired hanging
position.
Note: A new electric box comes with
screws. When replacing an existing
fixture, retain the screws for use with the
new fixture.
3. Using suitable wire connectors (not
provided); connect fixture wires to
supply wires (white to white and black to
black). Run a pigtail lead from crossbar
ground screw (E) to the function box and
connect all ground wires (Bare copper or
green to bare copper or green).
Caution: Make sure wire connectors are
twisted on securely, and no bare wire is
exposed.
4. Slide fixture canopy (A) over threaded
studs and push firmly to ceiling, making sure that no wires are pinched between fixture canopy and ceiling. Fasten
with knurled balls (D). Be sure studs (C) are fully seated in knurled balls (D)
(Figure 1)
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
26636
Page 2
Installation Instructions A278
For Semi-Flush 12-6740 Page 2 of 2
To Install Glass (Figures 2 & 3)
Component Parts
A Canopy
F Glass
G Decorative Assembly
H Ball Head Screws (3)
1. Install Decorative Assembly (G) onto glass (F). (Figure 2)
2. Install light bulbs. (Not Included.)
3. Raise glass (F) with decorative assembly (G) and install into canopy (A). (Figure 3)
4. Install (3) Ball Head Screws (H) and tighten to secure glass. Be sure not to over tighten.
5. Restore electricity at main breaker.
(Figure 2)
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
(Figure 2)
(Figure 3)
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
26636
Loading...