Assembly & Installation Instructions A208
For Antasia Semi-Flush 12-4710 & 12-4710E Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: After installation extra hardware and accessories are possible due to our kits are used on multiple products
and options.
To Assemble Fixture
(Figure 1)
Component Parts
A Fixed Arms (2)
B Loose Arm
C Glass
D Screw
1. Carefully unpack the fixture from the carton.
2. Loosen and remove screw (D) allowing loose arm (B) to be removed. Save for later use. Note: Arm is shipped
installed.
3. Slip glass (C) into two fixed arms (A).
4. Slip loose arm (B) up through hole in canopy and attach with screw (D) until snug.
(Figure 1)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
(continued)
22811
Assembly & Installation Instructions A208
For Antasia Semi-Flush 12-4710 & 12-4710E Page 2 of 2
To Install Fixture (Figure 2)
Component Parts
E Ground Screw
F Crossbar
G Threaded Stud (3)
H Canopy
I Barrel Knobs (3)
Caution: Be sure power is off at the main breaker box prior to installation
1. Thread studs (G) through appropriate
holes in crossbar (F) to match hole
centers in canopy (H). Move ground
screw (E) to another available threaded
hole if necessary.
2. Using two machine screws (not
provided) fasten crossbar (F) to the
electric box using outer oval holes to
orient fixture to desired hanging position.
Note: A new electric box comes with
screws. When replacing an existing
fixture, retain the screws for use with the
new fixture.
3. Using suitable wire connectors (not
provided); connect fixture wires to
supply wires (white to white and black to
black). Connect all ground wires to green
ground screw (E).
wire connectors are twisted on securely,
and no bare wire is exposed.
4. Slide fixture canopy (H) over threaded
studs (G) and push firmly to ceiling,
making sure that no wires are pinched
between fixture canopy and ceiling. Fasten
with barrel knobs (I). Be sure studs (G)
are fully seated in barrel knobs (I).
5. Install bulb. Socket swings for ease to install bulb.
Fluorescent version bulb is included.
6. Restore electricity at main breaker.
Caution: Make sure
(Figure 2)
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
22811
Loading...