Hubbardton Forge 124255 User Manual

Assembly & Installation Instructions A332

CAUTION: FAILURE TO INSTALL THI S FIXTURE PROPERLY MAY RESULT I N SERIO US PERSO NAL

(Figure 1)

Moonband Semi-Flush 124255 Page 1 of 2

INJURY OR DEATH AND PROPERTY DAMAGE. We reco mm e n d installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

To Install Fixture (Figure 1)

Component Parts

A Canopy
B Cross Bar
C Threaded Stud (3)
D Barrel Knobs (3)
E Ground screw

Caution: Be sure power is off at the main
breaker box prior to installation

1. Carefully unpack the fixture from the

carton.

2. Thread studs (C) through appropriate

holes in cross bar (B) to match hole
centers in canopy (A). Move ground
screw (E) to another available threaded
hole if necessary.

3. Using two machine screws (not

provided) fasten cross bar (B) to the
electric box using outer oval holes to
orient fixture to desired hanging position.

Note: A new electric box comes with
screws. When replacing an existing
fixture, retain the screws for use with the
new fixture.

4. Using suitable wire connectors (not

provided); connect fix tu r e w ires to
supply wires (white to white and black to
black). Connect all ground wires to green
ground screw (E).

Caution: Make sure wire connectors are
twisted on securely, and no bare wire is exposed.

5. Slide fixture canopy (A) over threaded studs and push firmly to ceiling, making sure that no wires are pinched

between fixture canopy and ceiling. Fasten with barrel knobs (D). Be sure studs (C) are fully seated in barrel
knobs (E).

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

28306

Assembly & Installation Instructions A332

(Figure 2)

Moonband Semi-Flush 124255 Page 2 of 2

To Install Glass (Figure 2)

Component Parts

F Glass
G Fixture Ring

1. Tilt glass (F) into fixture ring (G) and slide

underneath socket.

2. Repeat for other two pieces of glass.

3. Install light bulbs (not included)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

28306