Hubbardton Forge 103260 User Manual

Assembly & Installation Instructions A152

For New Town Six Light Chandelier 10-3260 Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

To Install to Ceiling (Figure 1)

Component Parts

A Fixture
B Stud (2)
C Ceiling Bracket
D Canopy Loop (2)
E Crossbar
F Lag Screw (4)
G Hex Nut (2)
H Canopy
I Loop Collar (2)
J Chain (2)
K Fixture Loop

1. Attach one end of the chain to the fixture loop (K). Lace the wire through

every other link of the chain (J) to the end.

2. Remove loop collar (I) from canopy loop (D).

3. Slide canopy (H) and loop collar (I) over canopy loop (D).

4. Fasten the chain to the canopy loop (D) and slip wires through the canopy

loop (D). Make sure to provide enough slack in the wire to ensure weight
of fixture is supported by the chain.

5. Using four lag screws (F) attach crossbar (E) to a structural member in the

ceiling, centering the crossbar over the outlet box. We've supplied lag
screws with your fixture; however, different materials and/or construction
methods may require different fasteners. If in doubt, contact a qualified

electrician. Do not attach crossbar directly to outlet box.

6. Raise fixture to ceiling allowing loop collar (I) and canopy (H) to rest

against chain (J), align studs in crossbar (E) with holes in ceiling
bracket (C).

7. Thread hex nut (G) onto studs (B) and tighten.

8. Using suitable wire connectors (not provided) connect fixture wires to supply (white to white and black to black,

and bare copper to bare copper or green supply). Push wires back into outlet box.

Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.

9. Raise canopy (H) to the ceiling and secure with loop collar (I) to canopy loop (D).

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

21201

(Figure 1)

(continued)

Assembly & Installation Instructions A152

For New Town Six Light Chandelier 10-3260 Page 2 of 2

To Install Glass

Component Parts

A Fixture
K Screw (6)
L Glass Ring (6)
M Glass (6)

1. Install light bulbs (Fluorescent version bulbs are provided).

2. Slip glass ring (L) over glass (M) making sure the counter sunk side of

hole is facing up. Install glass (M) aligning glass ring (L) hole with
threaded hole in fixture (A).

3. Install screw (K) to attach glass ring (L) to fixture (A).

4. Repeat steps two & three until all six glass pieces are installed.

5. Restore electricity at the main breaker.

(Figure 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

(Figure 2)

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

21201