Hubbardton Forge 103250 User Manual

Installation Instructions A137

g

For New Town Four Light Chandelier 10-3250 & 10-3255 Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum watta

To Install (Figure 1)

Component Parts

A Crossbar
B Lock Nut
C Nipple
D Canopy
E Loop Collar

Caution: Be sure power is off at the main breaker box prior to installation

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided), fasten the crossbar to the

electric box.

Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.

3. Thread the nipple (C) into the crossbar (A) and secure with lock nut

(B); slide canopy (D) over nipple, and attach the canopy loop (F) to the
nipple. Adjust the nipple to proper length to ensure a snug canopy fit
before proceeding.

4. Attach one end of the chain to the fixture loop (H). Lace the wire

through every other link of the chain (G) to the end. Slip wires and
chain through the collars and canopy (D, E & F). Fasten the chain to the
canopy loop, then slip wires through the loop and nipple, into the
electric box. Make sure to provide enough slack in the wire to ensure
weight of fixture is supported by the chain.

5. Using suitable wire connectors (not provided) connect fixture wires to

supply wires (white to ribbed side of the fixture cord, black to smooth
side). Connect all ground wires to crossbar ground screw.

Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.

6. Raise canopy to the ceiling and secure collar to canopy loop (F) with

loop collar (E).

e noted on fixture. Use only recommended bulbs with fixture.

F Canopy Loop
G Chain
H Fixture Loop
I Fixture

(Figure 1)

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

21137

Installation Instructions A137

For New Town Four Light Chandelier 10-3250 & 10-3255 Page 2 of 2

To Install Glass

Component Parts

I Fixture
J Screw (4)
K Glass Ring (4)
L Glass (4)

(Figure 2)

1. Install light bulbs (not provided).

2. Slip glass ring (K) over glass (L) making

sure counter sunk side is facing up. Install
glass (L) aligning glass ring (K) hole with
threaded hole in fixture (I).

3. Install screw (J) to attach glass ring (K) to

fixture (I).

4. Restore electricity at the main breaker.

(Figure 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

21137