Page 1
Installation Instructions A245
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
(Figure 1)
Flora Chandelier 10-3033 10-3035 & 10-3037 Page 1 of 2
INJURY OR DEATH AND PROPERTY DAMAGE. We rec o mm e nd installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products and
options.
To Install the Canopy (Figure 1)
Component Parts
A Ground Screw
B Crossbar
C Lock Nut
D Nipple
E Canopy
F Cano p y Loop
G Loop Collar
H Fixture Loop
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar (B) to
the electric box (s ee illustration).
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Thread the nipple (D) into the crossbar (B) and secure with lock nut
(C); slide canopy (E) over nipple (D), and attach the canopy loop (F)
to the nipple (D). Adjust the nipple to proper length to ensure a snug
canopy fit before proceeding.
4. Attach one end of the chain to the fixture loop (H). Lace the wire
through every other link of the chain to the end. Slip wires and chain
through the collars and canopy (G, F & E). Fasten the chain to the
canopy loop (F) then slip wires through the loop and nipple, into the
electric box. Make sure to provide enough slack in the wire to ensure
weight of fixture is supported by the chain.
5. Using suitable wire connectors (not provided) connect fixture wires to
supply wires (white to ribbed side of the fixture s cord, black to
smooth side). Run a pigtail lead from crossbar ground screw (A) to
the junction box and connect all ground wires (bare copper or green to
bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.
6. Raise canopy (E) to the ceiling and secure loop collar (G) to canopy
loop (F).
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
24613
(continued)
Page 2
Installation Instructions A245
(Figure 2)
Flora Chandelier 10-3033 10-3035 & 10-3037 Page 2 of 2
To Install Glass (Figure 2)
Component Parts
I Socket
J Bulb (included)
K Retaining Ring
L Glass
M Socket Tool
1. Remove retaining rings (K) from sockets (I). Retaining ring is shipped
installed.
2. Install light bulbs (J). Be careful not to touch bulb with bare hands; oil
from the hands will dramatically reduce bulb life.
3. Slip glass (L) over socket (I) and thread retaining ring (K) onto the socket
(I) using provided socket tool (M). Repeat for all the arms.
4. Restore electricity at the main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
24613
Loading...