Huawei Quidway S1700-8-AC User Manual & Installation Quick Start

Install the device on a worktable.

安装设备到工作台。

Mark the screw locations on the wall according to
the holes on the back of device.

根据设备后面板上的挂孔，用记号笔标记螺钉位置。

Rev: 02

膨胀套

Screw Ancrotron

膨胀套

Screw Ancrotron

技术支持

快速安装指南以及简易使用说明书

Service and Support

Installing the Device on a Worktable

安装设备到工作台

Tool List

工具参考

Quidway S1700-8-AC 以太网交换机

Quidway S1700-8-AC Ethernet Switch

User Manual & Installation Quick Start

Crosshead screwdriver

十字螺丝刀

羊角锤

Claw hammer

Marker pen

记号笔

电源适配器

Power adapter

Installing the Device on a Wall

安装设备到墙面

M6

螺钉

M6 screw

Accessories

(S1700-8-AC)

设备附件介绍(

S1700-8-AC

）

Percussion drill(φ8 Drill bit)

冲击钻（φ8钻头）

φ8 Drill bit

φ8钻头

90

。

Install the Screw Ancrotron.

安装膨胀套。

●To prevent injuries, check that there is no electrical wire at the locations to be drilled before drilling holes in the wall.

●

●

●

Flammable and explosive items under the device is prohibited. Leave more than 100 mm of space around the device for proper heat dissipation.

在墙上打孔时，必须确认打孔处没有墙电，避免造成人身伤害。

设备下方禁止摆放易燃易爆物品，距离设备100mm范围内不能有异物挡住。

4

Install the screws.

安装螺钉。

Connect the power adapter.

连接电源适配器

Install the device on the wall.

安装设备到墙面。

● Do not power on the device before device installation and cabling are completed.

● The S1700-8-AC can use only DC power supply.

● The power input of S1700-8-AC is 5V/1A.

● 严禁在设备安装和布线完成前向设备供电。

● S1700-8-AC只支持附带的电源适配器。

● S1700-8-AC电源输入为5V/1A。

Connecting Power Adapter

连接电源适配器

5