HQTELECOM.com LX009B-V6 User Manual

HQTELECOM.com Number Blocker

Version 6 User Manual

(Model LX009B-V6, Last Revised in January, 2016)

FEATURES:

 Block up to 1,000 unwanted phone numbers
 Block up to 5 area codes or prefixes (1-5 digits)
 Block calls showing as “OUT OF AREA” (--- O

---) or “PRIVATE” (--- P ---)

 Block calls with no phone number displayed
 Simple set up and easy to use
 Easy to read LCD display (2.5” x 1”) with Blue

backlight & 4 levels of brightness

 Stores phone numbers in non-volatile memory

(retains stored data if loses power)

 Stores up to 100 incoming calls (most recent)
 Stores up to 50 outgoing calls (most recent)
 Visual incoming call alert LED light
 Backup power via batteries (not included)
 FSK / DTMF dual system

IMPORTANT: CALLER ID

SERVICE IS REQUIRED FOR
THIS DEVICE TO WORK
PROPERLY.

WHAT’S IN THE BOX:

(1) Number Blocker Unit (1) Telephone Cable Patch Cord (~1 feet, 0.3 meters)
(1) User Manual

INSTALLATION:
Installing/Replacing Batteries (Optional but recommended):
This device is powered by your phone line but uses batteries as backup. To install/replace the
batteries, open the battery cover located in the back of the unit and insert three (3) AAA
batteries (not included). Please note the correct positioning (+ and -). Warning: Please
disconnect the AC adapter from the unit or the power outlet PRIOR to inserting or changing the
batteries.

Series Installation (option 1): Connect your phone line to the “LINE” port coming from wall or
form your phone service provider and then use small cord to connect “PHONE” port or socket
directly to actual phone set as shown in the figure below:

PARALLEL (Option 2): You may also install it in parallel with your phone(s) using a 2-way
splitter (not included), as shown below:

IMPORTANT: If using the parallel setup, you will still need to plug in a telephone handset to
the PHONE socket (at least temporarily) to program your call blocker.

PROGRAMMING:
PREPARATION: Before programming your call blocker, you will need the following:

1) A telephone handset connected on the PHONE socket of the Call Blocker.

2) You also need to be able to hear dialtone through the connected handset. You will need to
use your handset’s dialpad to program your call blocker.

BLOCK function setting
The blocking feature is set as “ON” at the factory. If you want to set the block function,

following these steps:
Step 1. Press [ SET ] button, the LCD screen should display “Set 123456”
Step 2. Lift off the handset (make sure you can hear the dial tone), and press [ 3 ] using the

dial pad, LCD should displays “On”.
Step 3. Press [ DWN ] button to change to “OFF” / “ON” if needed. Hang up. Done!

Once you complete the installation, your call blocker is ready to start blocking unwanted
numbers. Simply wait for incoming calls to ring, press the [ DWN ] button to review the

numbers and press the [ BLOCK ] button to block those numbers. It’s that easy! Programming

this device is completely optional.

3. Changing the LCD Display Brightness Level (Optional)
The factory default setting for the display brightness is 2. To change the setting: