CFREMOTEH
PLEASE READ ALL INSTRUCTIONS CAREFULLY. RETAIN FOR FUTURE REFERENCE.
INSTALLATION MUST BE CARRIED OUT BY A LICENSED ELECTRICAL CONTRACTOR.
Important considerations
1
CFREMOTEJ
Ceiling Fan Infrared Remote Control Kit
Instruction Manual
Cat. No: CFREMOTEH
CFREMOTEJ
Specications
Input voltage 230 - 240 V a.c. 50 Hz
Standby Power < 0.5 W
Output Rating Fan motor 65 VA max
Light 120 VA max
Light Dimmer Trailing Edge Dimmer
Box Contents
■ Receiver
■ Wall mount bracket
■ Remote control (with CR2025 battery included)
2
Mounting
1. The CFREMOTE range is compatible with HPM’s CF Series of Ceiling
Sweep Fans only.
2. CFREMOTEH is compatible with HPM Hang-Sure fans only.
CFREMOTEJ is compatible with HPM J-Hook fans only.
3. The infrared transmitter has a maximum working range of 10
metres (unobstructed).
4. The remote control cannot be used in combination with a wall
mounted fan controller.
5. The same remote control can be used to control several of HPM CF
ceiling fans tted with the receiver module.
6. Dimming function works with dimmable halogen, incandescent
and some LED lamps only. Compatibility with non-dimmable or
CFL lamps is not guaranteed. Dimming levels will vary depending
on the dimmable lamp.
7. Fan can be directly connected using the compatible cable
connectors on the Remote Control Kit.
Hand-held Remote
Mode Operation
Timer
Allows the fan to run
for a further 2/4/6
All ON/OFF
2H
Timer
2, 4 & 6 hour
6H4H
hours of operation
before switching o
automatically.
Does not aect the
light output.
J-Hook Bracket
Hang the fan on the J-Hook.
Ensure that all wires are clear of the rubber roller.
Position the receiver in the cowling.
Place the sensors on edge of
cowling at opposite ends.
Tighten the 2 screws to the
downrod.
Hang-sure Bracket
Hang the fan on the bracket.
Ensure bracket guide pin is
tted into slot on ball joint
and that all wires are clear
of the ball joint.
Battery Lid screw
Light
Low, med & high
Fig. 1
Fan Speed
Low, med & high
Wall-mount
bracket
included
Fan
Speed
Light
3 fan speeds can be
selected.
FAN OFF will switch
o fan when in
Timer mode.
3 light levels can be
selected. Requires a
dimmable lamp to be
tted in lighting kit.
Place the sensors on edge of
cowling at opposite ends.
Insert the receiver into the
Hang-sure bracket.
Fix the cowling to the bracket
by tightening the 2 screws.
3 6
Wiring
Product Notes
1. Isolate 240V mains power to circuit.
2. Connect the plug (mains terminal block) to the socket
connector from the fan.
3. Connect supply wiring to mains terminal block provided. When
installing the CFREMOTEH, ensure Hang-sure mounting
bracket is earthed as per sweep fan instruction sheet.
4. Reconnect power to circuit.
Neutral
Remote
control
receiver
Active
4
Wall mounting of Remote Control
1. Fix bracket to wall in a suitable location indoors.
2. Open the battery compartment in the remote and remove
protective sleeve from battery.
3. Test fan operation.
5
Battery Warnings
■ This product contains a button Lithium battery.
■ Ensure the device’s battery compartment is secured with
screw provided (refer to battery lid screw, Fig. 1 on front page).
Do not use if compartment is not secure.
■ Flat batteries can still be dangerous. Dispose of used batteries
safely. Swallowing may lead to serious injury or death.
■ If you suspect a child has swallowed or inserted a button battery,
call the 24 Hour Poisons information Center on 131126 for expert
advice.
1. This product must be installed by a licensed electrician and
used as per these instructions.
2. During installation a switch disconnection should be
incorporated in the supply circuit.
3. This product contains no serviceable parts and no attempt
should be made to repair this product. If the product is faulty
it should be discarded.
4. This product has been designed to operate in ambient
temperatures between 5°C to 40°C.
5. This product is not intended to be exposed to direct weathering.
It is not suitable for installation in hazardous and/or corrosive
areas.
6. This product is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of this
product by a person responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.
7. This product has been designed to operate on a nominal supply
voltage of 230V -240Va.c. 50 Hz.
8. Electrical installations periodically receive transient over
voltages. This product has been designed to minimise the
eect of such voltages on connected equipment. It may not
give full protection for extreme over voltage transients such as
those resulting from a close lighting strike.
9. After installation this product must be tested as required by the
appropriate government and/or statutory regulations.
10. Keep away from children.
11. This product utilises intellectual property in the form of registered
designs, trademarks, and/or patents. Such intellectual property
remains the property of Legrand in all cases.
12. Legrand reserves the right to modify the specication of this
product at any time.
Warranty
Legrand warrants this product for a period of 2 years from the date of purchase.
These goods come with guarantees that cannot be excluded under the Australian
and New Zealand Consumer Laws. You are entitled to a replacement or a refund for
a major failure and for compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired if the goods fail to be of
acceptable quality and the failure does not amount to a major failure.
See the Warranty card enclosed with this product for further details.
Customer Service
For all Customer Service and Technical Support
please call Monday to Friday during business hours.
Legrand Australia
1300 369 777
www.hpm.com.au
ABN: 31 000 102 661
Legrand New Zealand
0800 476 009
www.hpm.co.nz
Paper
LE12801AA 02/2021
Loading...