HPE P19563-B21 Product Data Sheet

QuickSpecs

HPE Smart Array S100i SR Gen10 Software RAID

Overview

Page 1

HPE Smart Array S100i SR Gen10 Software RAID

HPE Smart Array S100i SR Gen10 Software RAID, supporting 6Gb/s SATA, is an ideal entry-level solution for supporting RAID 0, 1,

Array S100i SR Gen10 SW RAID is only supported on Windows.

Key Features

• Storage interface (SATA)

• Seamless upgrades to HPE Smart Array controllers

Ports

• Internal: Up to 14 SATA lanes (dependent on server)

Performance

• 6Gb/s SATA (600 MB/s theoretical bandwidth per physical lane)

• PCI Express 3.0 x4 link width

Fault Prevention

The following features offer detection of possible failures before they occur:

allowing replacement of the

• HPE SmartSSD Wear Gauge reports the amount of lifetime remaining on your SSDs.

Storage Management

HPE Smart Storage Administrator (SSA) GUI

HPE Smart Storage Administrator (SSA) CLI

HPE Smart Storage Administrator (SSA) Scripting

HPE Intelligent Provisioning

UEFI System Utilities (storage configuration)

NOTE: For additional information see the HPE Smart Array SR Gen10 Configuration Guide
at: http://www.hpe.com/info/SmartArrayGen10-docs

5, and 10. Smart Array Software (SW) RAID is a driver based solution that enables RAID on up to 14 SATA drives connected to the
embedded SATA ports on the system board. This software RAID solution is available for HPE ProLiant Gen10 servers and HPE
Synergy Gen10 compute modules and provides the efficiency needed to address your evolving data storage needs. HPE Smart

o Up to 14 SATA lanes
o 6Gb/s SATA technology

• RAID 0, 1, 5, and 10

• UEFI System Utilities (storage configuration)

• Up to 14 physical drives

• Up to 14 logical drives

• Predictive drive failure detects possible drive failure before it occurs,

component before failure occurs.

• Background surface scan checks drives during inactive periods and automatically remaps bad

sectors, ensuring data integrity.

Software Suite

QuickSpecs

HPE Smart Array S100i SR Gen10 Software RAID

Compatibility

Page 2

Server Compatibility

HPE Smart Array S100i SR Gen10 Software RAID is offered on all ProLiant Gen10 servers and Synergy
Gen10 compute modules.

Operating Systems

Microsoft Windows Server

Microsoft Windows Hyper-V Server

NOTE: S100i Software RAID only supports Windows. For Linux users, HPE offers a solution that uses

visit: http://www.hpe.com/info/ossupport

in-distro open-source software to create a two-disk RAID 1 boot volume. For more information

https://downloads.linux.hpe.com/SDR/project/lsrrb/

visit:
NOTE: Customers using Linux and VMware can use the embedded SATA ports in AHCI mode. In
AHCI mode S100i Software RAID is not enabled.

NOTE: For more information on HPE's server operating systems and virtualization software, please