HPE J9150A Getting Started Guide
RETIRED: Retired products sold prior to the November 1, 2015 separation of Hewlett-Packard Company into Hewlett Packard Enterprise Company and HP Inc. may
have older product names and model numbers that differ from current models.
QuickSpecs
Overview
Models
HP X132 10G SFP+ LC SR Transceiver
HP X132 10G SFP+ LC LR Transceiver
HP X132 10G SFP+ LC LRM Transceiver
HP X132 10G SFP+ LC ER Transceiver
HP SFP+ Transceivers (SR, LRM, LR and ER)
J9150A
J9151A
J9152A
J9153A
DA - 13285 Worldwide — Version 3 — September 5, 2012
Page 1
RETIRED: Retired products sold prior to the November 1, 2015 separation of Hewlett-Packard Company into Hewlett Packard Enterprise Company and HP Inc. may
have older product names and model numbers that differ from current models.
QuickSpecs
Technical Specifications
HP X132 10G SFP+ LC SR
Transceiver
A 10-Gigabit transceiver in
SFP+ form-factor that
supports the 10-Gigabit SR
standard, providing 10Gigabit connectivity up to
300 m on multimode fiber.
(J9150A)
Ports
Connectivity
Physical characteristics
Environment
Electrical characteristics
Cabling
HP SFP+ Transceivers (SR, LRM, LR and ER)
1 LC 10-GbE port (IEEE 802.3ae Type 10Gbase-SR); Duplex: full only
Connector type
Wavelength
Dimensions
Weight
Transceiver form factor
Operating temperature
Operating relative
humidity
Nonoperating/Storage
temperature
Altitude
Power consumption
typical
Power consumption
maximum
Cable type:
62.5/125 µm or 50/125 µm (core/cladding) diameter, graded-index, low metal
content, multimode fiber optic, complying with ITU-T G.651 and ISO/IEC 793-2
Type A1b or A1a, respectively;
Maximum distance:
LC
850 nm
2.19(d) x 0.54(w) x 0.47(h) in. (5.57 x 1.38 x 1.19
cm)
0.04 lb. (0.02 kg)
SFP+
32°F to 158°F (0°C to 70°C)
0% to 85%, noncondensing
-40°F to 185°F (-40°C to 85°C)
up to 10,000 ft. (3 km)
0.6 W
0.8 W
Notes
Services
2-26m with 62.5 µm multimode cable @ 160 MHz*km
2-33m with 62.5 µm multimode cable @ 200 MHz*km
2-66m with 50 µm multimode cable @ 400 MHz*km
2-82m with 50 µm multimode cable @ 500 MHz*km
2-300m with 50 µm multimode cable @ 2000 MHz*km
Cable length
Fiber type
For fiber patch cords, use Ultra Physical Contact (UPC) surface
termination/polish. Angled Physical Contact (APC) is not recommended.
Refer to the HP website at:
the service-level descriptions and product numbers. For details about services
and response times in your area, please contact your local HP sales office.
2-300m
Multi Mode
www.hp.com/networking/services
for details on
DA - 13285 Worldwide — Version 3 — September 5, 2012
Page 2
Loading...