HP Workstation xw4200 Power Cord Set Requirements

Appendix F Power Cord Set Requirements

This appendix discusses the power cord set requirements for the HP Workstation xw4200.

The power cord set (flexible cord or wall plug) received with this product meets the requirements for use
in the country where you purchased the equipment.

If you must obtain a power cord for a different country, you should purchase a power cord that is
approved for use in that country.

The power cord must be rated for the product and for the voltage and current marked on the product’s
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and
current rating marked on the product. In addition, the diameter of the wire must be a minimum of

0.75 mm
you have questions about the type of power cord to use, contact the HP authorized service provider.

A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it
or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord
exits from the product.

2

or 18AWG, and the length of the cord must be between 6 feet (1.8 m) and 12 feet (3.6 m). If

Appendix F

173

174 POWER CORD SET REQUIREMENTS