HP PAVILION SLIMLINE S7200, PAVILION SLIMLINE S7300 User Manual

Upgrading and Servicing Guide

The only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing herein
should be construed as constituting an additional warranty. HP shall not be liable
for technical or editorial errors or omissions contained herein.

HP assumes no responsibility for the use or reliability of its software on equipment
that is not furnished by HP.

This document contains proprietary information that is protected by copyright. No
part of this document may be photocopied, reproduced, or translated to another
language without the prior written consent of HP.

Hewlett-Packard Company
P.O. Box 4010
Cupertino, CA 95015–4010
USA

Copyright © 2005 Hewlett-Packard Development Company, L.P.

This product incorporates copyright protection technology that is protected by
method claims of certain U.S. patents and other intellectual property rights owned
by Macrovision Corporation and other rights owners. Use of this copyright
protection technology must be authorized by Macrovision Corporation, and is
intended for home and other limited viewing uses only unless otherwise authorized
by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
Apparatus Claims of U.S. Patent Nos. 4,631,603, 4,577,216, 4,819,098, and
4,907,093 licensed for limited viewing uses only.

Microsoft and Windows are U.S. Registered trademarks of Microsoft Corporation.

HP supports lawful use of technology and does not endorse or encourage the use
of our products for purposes other than those permitted by copyright law.

The information in this document is subject to change without notice.

Table of Contents

Introduction.................................................................................... 1

Safety Information ......................................................................... 1

Opening the PC .............................................................................. 2

Preparing the PC ......................................................................................2

Removing the PC Cover.............................................................................3

Locating Components Inside the PC ............................................................4

Closing the PC ................................................................................ 5

Replacing the PC Cover.............................................................................5

After Closing the PC..................................................................................5

Removing and Replacing an Optical Disc Drive ............................... 6

Before You Begin ......................................................................................6

Removing an Optical Disc Drive .................................................................6

Replacing an Optical Disc Drive.................................................................8

Removing and Replacing a Hard Disk Drive ................................. 10

Before You Begin ....................................................................................10

Removing a Hard Disk Drive ....................................................................10

Replacing a Hard Disk Drive ....................................................................12

Removing and Replacing Memory ................................................ 13

Before You Begin ....................................................................................13

Removing a Memory Module ...................................................................14

Replacing a Memory Module ...................................................................15

Removing and Replacing a PCI Card............................................. 16

Before You Begin ....................................................................................16

Removing a PCI Card..............................................................................16

Replacing a PCI Card .............................................................................17

Removing and Replacing the Battery............................................ 18

Before You Begin ....................................................................................18

Upgrading and Servicing Guide

iii

iv Upgrading and Servicing Guide

Introduction

WARNING: Keep your hands away from the moving fan. Keep fingers and tools clear

The Upgrading and Servicing Guide provides instructions on how to
remove and replace the following hardware components in your Slimline
PC:

• Optical disc drive

• Hard disk drive

• Memory module

• Modem card (PCI card)

• Battery

Safety Information

Please read the following important safety information before performing
any procedure.

This product has not been evaluated for connection to an “IT” power
system (an AC distribution system with no direct connection to earth,
according to IEC 60950).

WARNING: Please read “Safety Information” in your Warranty and Support Guide before
installing and connecting your system to the electrical power system.

of the fan when power is applied. Never open the cover with the power cord
attached or power applied. You may damage your PC or be injured from the
spinning fan blades.

WARNING: Avoid touching sharp edges inside the PC.

Upgrading and Servicing Guide 1

Opening the PC

W

Before you upgrade any component in your PC, prepare the PC so that you can safely handle the unit and the
components.

Read the following items before attempting to upgrade or service the PC:

• Print out this document before attempting any removal/replacement procedures.

• These procedures assume familiarity with the general terminology associated with PCs and with the safety

practices and regulatory compliance required for using and modifying electronic equipment.

• Write down and save the system model number and serial number, all installed options, and other information

about the system. If you need this information later, you will not need to open up and examine the PC.

CAUTION: Static electricity can damage the electronic components of the PC or optional
equipment. Ensure that you are discharged of static electricity by briefly touching a grounded
metal object.

• HP recommends that you use an antistatic wrist strap and a conductive foam pad when working on system

electronic components.

• You need a Phillips screwdriver.

Preparing the PC

To avoid injury and equipment damage, always follow this procedure in this order before opening the PC:

1 Remove any memory card from the memory card reader or an optical disc (CD or DVD) from the optical drive.
2 Turn off the PC:

a Click the Start button on the taskbar.
b Click Turn Off Computer and then click Turn Off again.

3 Disconnect the modem/telephone cable, if present.

WARNING: Always disconnect the modem cord from the telephone system before opening the
cover.

4 Disconnect the power cord from the electrical outlet and then from the PC.

ARNING: To reduce the risk of personal injury from electrical shock or hot surfaces, disconnect
the power cord from the electrical outlet. Then disconnect the PC from the power source before
removing the PC cover. Failure to do so before you open the PC or do any procedures can result
in personal injury or equipment damage.

5 Disconnect all other attached cables (such as the keyboard, mouse, Ethernet, and monitor).
6 Disconnect all external devices.

2 Upgrading and Servicing Guide

Removing the PC Cover

WARNING: Remove power before opening the
PC cover. Allow the internal system components
to cool before touching.

1 Complete the procedure “Preparing the PC” on page 2.
2 Lay the PC flat.
3 Loosen the three screws on the back cover. Use a Phillips

screwdriver.

WARNING: Avoid touching sharp edges inside
the PC.

4 Slide the PC cover back about 1.25 cm (1/2 inch) (A),

and then lift it off the PC (B). Set it aside.

NOTE: Use the screwdriver slot on the back of the cover to loosen the cover, as required.

Upgrading and Servicing Guide 3

Locating Components Inside the PC

PC component configurations vary by model. You can remove and replace the following components:

Component See:

A Optical disc drive. May be a CD-ROM, CD-RW,

DVD-ROM, DVD+RW, or combination drive.

B Hard disk drive

(located under the optical drive bay)

C Memory module “Removing and Replacing Memory” on page 13

D Modem card (PCI card) “Removing and Replacing a PCI Card” on page 16

E Battery “Removing and Replacing the Battery” on page 18

Read the “Before You Begin” section at the start of each component procedure. This section contains
requirements and important information about the replaceable component.

The following illustration shows component locations:

“Removing and Replacing an Optical Disc Drive” on page 6

“Removing and Replacing a Hard Disk Drive” on page 10

4 Upgrading and Servicing Guide