HP Compaq Presario V3200 CTO, Compaq Presario V3218LA, Compaq Presario V3230AU, Compaq Presario V3231AU, Compaq Presario V3241AU User Guide

...
Memory Modules
User Guide
© Copyright 2007 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.
First Edition: January 2007
Document Part Number: 430306-001
Table of contents
Replacing a memory module
Index ..................................................................................................................................................................... 6
ENWW iii
iv ENWW

Replacing a memory module

The computer has one memory module compartment, which is located on the bottom of the computer. The memory capacity of the computer can be upgraded by adding a memory module to the vacant expansion memory module slot or by upgrading the existing memory module in the primary memory module slot.
WARNING! To reduce the risk of electric shock and damage to the equipment, unplug the
power cord and remove all batteries before installing a memory module.
CAUTION Electrostatic discharge (ESD) can damage electronic components. Before
beginning any procedure, ensure that you are discharged of static electricity by touching a grounded metal object.
To replace a memory module:
1. Save your work and close all open programs.
NOTE If the computer is in the Sleep state or in Hibernation, you must first exit Sleep or
Hibernation before shutdown is possible.
2. Click Start, click the arrow next to the Lock button, and then click Shut Down.
3. Close the display.
4. Disconnect all external devices connected to the computer.
5. Unplug the power cord from the AC outlet.
6. Turn the computer upside down on a flat surface.
7. Remove the battery from the computer.
8. Loosen the 2 memory module compartment cover screws (1).
ENWW 1
9. Lift the memory module compartment cover (2) away from the computer.
10. Remove the memory module:
a. Pull away the retention clips (1) on each side of the memory module.
The memory module tilts up.
CAUTION To prevent damage to the memory module, hold the memory module by
the edges only. Do not touch the components on the memory module.
2 Replacing a memory module ENWW
b. Grasp the edge of the memory module (2), and gently pull the module out of the memory
module slot.
To protect a memory module after removal, place it in an electrostatic-safe container.
11. Insert a new memory module:
a. Align the notched edge (1) of the memory module with the tab in the memory module slot.
CAUTION To prevent damage to the memory module, hold the memory module by
the edges only. Do not touch the components on the memory module.
b. With the memory module at a 45-degree angle from the surface of the memory module
compartment, press the memory module (2) into the memory module slot until it is seated.
ENWW 3
c. Gently press the memory module (3) down, applying pressure to both the left and right edges
of the memory module, until the retention clips snap into place.
CAUTION To prevent damage to the memory module, be sure that you do not bend
the memory module.
12. Align the tabs (1) on the memory module compartment cover with the notches on the computer.
13. Close the cover (2).
14. Tighten the 2 memory module compartment cover screws (3).
4 Replacing a memory module ENWW
15. Replace the battery.
16. Reconnect external power and external devices.
17. Turn on the computer.
ENWW 5

Index

M
memory
replacing memory modules 1
memory module
inserting 3 removing 2 replacing 1
memory module compartment
cover
removing 2 replacing 4
6 Index ENWW
Loading...