Hottop 9815, 9815D, 9815SD, 9818, 9815S Use And Mantainance

1

Riscaldatore a raggi infrarossi ad onde lunghe

Classe 1-IP55

MANUALE D`USO E MANUTENZIONE

USE AND MANTAINANCE

NOTICE D’UTILISATION ET D’ENTRETIEN

GEBRAUCH UND WARTUNG

9815 - 9815D - 9815S - 9815SD 9818 - 9818D - 9818S - 9818SD
9824 - 9824D - 9824S - 9824SD 9832 - 9832D - 9832S - 9832SD

20

Introduction to the product

Supply voltage 220-230 V

50-60 Hz

240 V

50-60 Hz

120 V
60 Hz

Insulation class I

IP level IP55

Emission spectrum IR-C

Technical specifications

HOT-TOP is the IR-C heater

which surrounds you with his
soft and cozy warmth.

HOT-TOP is perfect in focusing
its warmth in defined areas
indoor or outdoor. You can use
it as long as you like, since
its warmth is invisible. You
won’t see any luminous ray,
but it functions like the sun,
warming the bodies instead the
air. For this reason there is no
need to warm-up the complete

environment for feeling good.
It is perfect for restaurants,
offices, supermarkets,
factories and patios.

It emits no light on, but as the
sun radiating bodies without
heating the air, dedicating
his warmth to people. Other
types of heating, however,
must first warm up the entire
environment before you
receives the benefit.

21

HOT-TOP means soft warmth

and swaths your body making
you feeling like closed to a
chimney corner.

HOT-TOP doesn’t dry the air

and doesn’t lift dust.

It doesn’t need gas or propane,
for this reason it doesn’t emit
any combustion refuse.
In comparison with gas heating
its maintenance is easier and
cheaper.

Its efficiency is higher,
if compared with other
tubular heaters on duct,
because its shape enhances
the front radiating surface
and decreases the warmth
dispersion from the rear
side. It is also for this reason
that the minimum distance
from the wall or the ceiling is
shorter.

The top quality material and
strongest surface casting
make it more resistant
than ever. Weather and use
won’t damage it. The tubular

resistances on duct have been
volcanized with silicon in order
to make them lasting longer
and longer.

Design, engineering and
production made in Italy.

Designed by Pino Spagnolo it

matches a decorating element
with an heavy duty heater.

Being rated IP55 can also be
installed outdoor.

It can be easily installed

on walls or ceilings. Its
accessories permit you to
adjust it at your desire.

3 years warranty

Benefits

22

Safety instructions

1.

This appliance is intended solely for the use it has been designed
for, namely room and people heating. The Manufacturer is not
responsible for any damage that could happen for improper use.

2.

After unpacking make sure that the appliance is complete and
shows no signs of visible damage or tampering.

3.

The device can be used by children at least 8 years (as well as by
persons with reduced physical, sensory or mental capabilities,
or lack of experience or required knowledge) provided that
they are under surveillance, or after they have been instructed
relating to the safe use and have understood the potential
dangers. Cleaning and maintenance must be performed by the
user and not by unsupervised children.

4.

- Children of less than 3 years should be kept away unless
continuously supervised.

- Children aged from 3 years and less than 8 years shall only
switch on/off the appliance provided that it has been placed or
installed in its intended normal operating position and they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.

- Children aged from 3 years and less than 8 years shall not
plug in, regulate and clean the appliance or perform user
maintenance.

Instructions should be carefully read before installation
and retained by the user. The booklet must be keeped
and delivered to the new user in case of cession of the
machine. The Manufacturer reserves the right to vary
the features of the product without prior notice. The
technical data are merely indicative.

23

This heating appliance does not feature a device to
control ambient temperature.
Do not use it in small rooms used by people who are
unable to leave such rooms on their own unless they
are under constant surveillance.
All users should be made aware of all aspects of
operation and safety and these instructions should be
retained for reference.

5.

Children should be supervised to ensure that they do not play
with the appliance.

6.

Do not use in presence of gas, inflammable or explosive liquids
or substances. Defined in BS5345.

7.

Some fundamental rules which apply to all electrical devices
must be observed when using the heater:

- Do not touch the heather with wet hands.

- Do not handle with bare feet.

- Do not let children play with the electrical appliance.

8.

Do not apply any modification to the product.

9.

Keep connections dry.

10.

If the power supply cord is damaged, avoid to use the appliance.
For power cord replacing, please contact the manufacturer or
the technical service or a person with similar qualification, in
order to avoid any risk.

11.

If the appliance is not used for a long period, disconnect it from
the power supply.

24

Electrical installation

Warnings

Before connecting the appliance make sure that
the voltage is the same as indicated on the device
and the line supply is corresponding to the effective
rules.

The installation should always be carried out by a qualified
electrician or a competent person in accordance with the
current electrical standards:
HD 384 CENELEC for Mainland Europe, IEC 60446 and BS
7671 for the United Kingdom, IEC 60445(2010) & ET101:2008
for Ireland and IEC 60364-7 1988 Internationally.
The energy supply to the heater must always be properly
earthed.

The appliance must be connected to energy supply line by
means of the provided H05SS-F silicone cable.
An overvoltage category III Combined Circuit breaker and
Residual Current Device (RCD) with rated earth leakage
operation not exceeding 30mA must be fitted upstream on the
supply line. The circuit breaker must have a contact opening
distance of at least 3 mm.

The product is in class I and IP55, wich is the protection rate
forthe units to be used even outdoor. For keeping the protection
rate of the appliance, the connection of the appliance with the
power supply must be done by means of a minimum IP55
system, as per the standards HD 384 CENELEC for Europe,
or international IEC 60364-7 1988.

25

–

Under no circumstances turn the appliance on if it is on
any surface.

-

A safety distance of not less than 100 cm should always
be left in front of the heaters or too near.

-

The appliance must not be located neither directly below,
nor in front of a socket-outlet.

-

The heater must be installed so as to prevent that the
switches can be touched from those who are in the
shower.

-

Avoid the use of an extension cord with this product,
because the extension cord may overheat and cause a
risk of fire.

-

Ensure that there is no possibility of inflammable
material, combustible material or curtains coming into
contact with the heater, or lie near the heater.

Additional information

Active

Neutral

Earth

Circuit
breaker

RCD Fuse*

* 10A (mod. 9815 - 9818)
16A (mod. 9824 - 9832)

26

Remote-controlled model

Dimmer Module

- Insert into the remote
control 2 batteries 1.5V
AAA (not included),
matching the polarities.

- Connecting the machine:
the blue LED lights
flashing.

- Use the remote control
as shown in figure.

For maximum flexibility all
models are available with
dimmer to adjust the intensity
of the heater comfortably by
remote control.

The length of each model
increases by 15 cm, while
the width and height remain
unchanged.

CAUTION!
Some parts of this product can become very hot and
cause burns. Particular attention has to be given
where children and vulnerable people are present.

27

POWER

HIGH

select max power:
the red LED lights
on.

MED

select 2/3 of power:
the violet LED lights
on.

LOW

select 1/3 of power:
the blue LED lights
on.

OFF

shutdown device.

ON

ignition device,
which leads LOW
power.

28

Model and warmth diffusion

POWER 1500W

RADIATE AREA 3150cm²

RANGE 5 m²

WEIGHT 5,7kg

Small

Medium

POWER 1800W

RADIATE AREA 3650cm²

RANGE 7 m²

WEIGHT 6,4kg

2,5m

1,8m 2m

1,25m

1,1m

2m

1,6m 2m

95mm

202mm

58mm

29

POWER 2400W

RADIATE AREA 4575cm²

RANGE 9 m²

WEIGHT 7,8kg

Large

POWER 3200W

RADIATE AREA 5850cm²

RANGE 12 m²

WEIGHT 9,8kg

Extra Large

1,55m

3m

2m

2m

1,95m

4m

3m 2m

Temperature increase

+16

+5

+10

30

30cm

180cm

50cm50cm

Safety distances

-

The heater must be installed at a
minimum height of 180 cm.

-

If installed in a toilet, the height
should be 225 cm in zone 1 and zone
2; in zone 3 the minimum above
ground level is 180 cm, according
with the rules of each Country.

-

A minimum air gap of 30 cm should
always be allowed between the top of
the heater and a ceiling or roof. The
appliance should be 50 cm far from
the walls

31

-

The heater must not be directed
towards the ceiling or flammable
materials.

-

The device must not be mounted into
the ceiling. You must leave enough
space around the top of the unit to
ensure good ventilation.

-

Do not use the heater in close
proximity of a bath, shower or
swimming pool.

-

If there is nobody in the room to be
heated, it is recommended to turn off
the unit.

Wait 15-20 minutes after power to reach the
maximum temperature.

32

The support to be fixed to the wall
presents a series of holes that
allow to fix the heater in different
positions.

cod. 004456

Provided wall/ceiling support

33

End to end

cod. 7705

Twin

cod. 7704

Extension

cod. 7706

Optional supports

34

Mounting

Before being used, the heater must be fixed to
the wall or to the ceiling by means of the provided
supports.

Ensure that the wall
where you intend
to attach the device
is solid and that
within it do not pass
electric cables or
water pipes.

9,6cm

* recommended value:

Small 80cm*
Medium 95cm*
Large 125cm*
Extra Large 180cm*

1.

Drill four holes in the wall
as shown below.

2.

Fix the two supports to
the wall using dowels of
appropriate size.

35

3.

Insert the arch­shaped support
in the special rail
on the upper side
of the device.

4.

Align the holes of the supports and join them together using
the supplied bolts, setting the desired inclination.

Ensure that the heater turns her rays in the area to be heated.
Firmly tighten the screws when finished.

36

To clean, use a soft damp cloth and then dry thoroughly. Make sure
all parts are dry before using again.

Avoid the use of harsh detergents, solvents, and abrasive or aerosol
cleaners as they may damage surfaces.

To avoid risk of failures it is necessary to operate the unit for a few
hours every 6 months.

If you have any question relevant your appliance, call the local
authorized distributor or the nearest Service Centre. Every repairs
should be carried on by an authorized Service Centre and also ask
always for original spare parts.

Technical service

Care and cleaning

Before cleaning, be sure the appliance is disconnected
from the power supply and allowed to cool.
Never immerse the appliance in water or any other
liquid.

Always disconnect the appliance before doing any
maintenance operation.
Cleaning and maintenance must be performed by the
user and not by unsupervised children.

37

It is the user’s responsibility to dispose of this appliance through
the appropriate channels at the end of its useful life. Failure to do
so may incur the penalties established by laws governing waste
disposal.
Appropriate separate collection for the subsequent dispatch of the
appliance for recycling, treatment and environmentally compatible
disposal helps prevent negative impact on the environment and
human health and promotes recycling of the materials making up
the product.

For more detailed information regarding the collection systems
available, contact your local waste disposal service or the shop
where you purchased the product.
Producers and importers comply with their responsibility for the
recycling, treatment, environmentally friendly disposal, either
directly or by participating in a collective system.

Disposal

This product conforms to EU Directive 2002/96/EC.

This appliance bears the symbol of the barred waste
bin. This indicates that, at the end of its useful life, it
must not be disposed of as domestic waste, but must
be taken to a collection centre for waste electrical
and electronic equipment, or returned to a retailer
on purchase of a replacement.

74

Mo-El S.r.l.

Via Galvani 18, 42027

Montecchio Emilia (RE) ITALY

Tel.: [phone]
Fax: [phone]

[e-mail]

www.mo-el.com

Questo manuale è disponibile in formato digitale sul sito

This manual is available in digital format on the website

Ce manuel est disponible en format numérique sur le site

Dieses Handbuch ist in digitaler Form auf der Website

Este manual está disponible en formato digital en el sitio web

Este manual está disponível em formato digital no website

هذا الدليل هو متاح في شكل رقمي على الموقع

www.mo-el.com