Hotpoint WF760, WTV70, WF325, WF545, WF350 Installation And Troubleshooting Manual
...
Installation and Troubleshooting Guide
Description
2
GB
●
Please record the Model
number and Serial number
of your machine on the back
cover of this book for future
reference.
! The machine was designed and built in
compliance with the applicable international
safety regulations.
The following information is provided for
your safety and should consequently be read
carefully.
Interlocking door and
release lever.
Front adjustable feet
Back feet
Dispenser drawer Control panel
(
●
Varies by Model)
Mains cable
Cold water inlet point
and attached fill hose
(blue connector)
Drainage hose
Hooked end support
Rating plate
Two transit fixings
! BOTH must be removed BEFORE
you use your machine (see page 5).
Plumbing indicator line
Contents
Description, 2
Installation, 4-7
Unpacking
Remove the transit fixings
Location
Levelling
Water connection
Drainage connection
Electrical connection
Before you start using your machine
Detergents and Laundry, 8
Detergent dispenser
Washcare tips
Preparing your laundry
Precautions and Advice, 9
General safety
Saving energy and respecting the environment
Disposal
Care and Maintenance, 10
Cleaning your machine
Fuses
Changing the plug
Cleaning the pump
Troubleshooting, 11
Service, 12
Before calling for assistance
Spare parts
Key Contacts
3
Description
Contents Installation
Detergents and
Laundry
Precautions and
Advice
Care and
Maintenance Troubleshooting Service
GB
Installation
GB
! Keep this instruction book on hand in order to refer to it
when necessary. Take it with you when you move, and
should you sell this appliance or pass it on to another
party, make sure that this booklet is supplied along
with the appliance so that the new owner may be
informed about warnings and suggestions on how the
machine works.
Unpacking
1. Using scissors, cut
carefully along one corner
post to remove the film.
2. Open the door and
check inside the drum.
Remove the transit tube (if
applicable - not all models).
! Retain all packaging
material until installation
is complete.
3. Lift off the polystyrene
top cap and remove the
four corner posts.
4. Carefully lay the left
side of the machine down
onto the top cap.
! We recommend that a
second person helps to
raise and lower the
machine.
5. Remove the
polystyrene base.
! This is a part of the
polystyrene base and
should have stayed intact
when you removed the
base.
●
If it has broken off and is still in the machine...
r
emove it
... while the machine is still laying on its
side on the top cap.
6. Cut out the perforated
shape in the transit tube
you removed from the
drum (if applicable - see
Step 2). Follow instructions
listed on the cut out to fit it
to the base of the machine.
When fitted this panel aids
noise reduction.
7. Stand the machine
upright.
! We recommend that a
second person helps to
raise and lower the
machine.
! Protect the environment - please dispose of the
packaging material carefully and considerately.
! Continue to read the
rest of these instructions
carefully; the following
pages contain important
information on installation
and troubleshooting.
! IMPORTANT check
when unpacking your
machine:
4
Loading...