Hotpoint STM 1601 V User Manual

Operating Instructions

2-DOOR FRIDGE

GB

English, 1

ES

Espanol, 11

STM 1601 V (AG)

Contents

GB

Installation, 2

Positioning and connection
Reversible doors

Description of the appliance, 3

Overall view

Start-up and use, 4-5

Starting the appliance
Setting the temperature
Using the refrigerator to its full potential
Using the freezer to its full potential

Maintenance and care, 6

Switching the appliance off
Cleaning the appliance
Avoiding mould and unpleasant odours
Defrosting the appliance
Replacing the light bulb

Precautions and tips, 7

General safety
Disposal
Respecting and conserving the environment

Troubleshooting, 8

Assistance, 9

Installation

! Before placing your new appliance into operation please

GB

read these operating instructions carefully. They contain
important information for safe use, for installation and for
care of the appliance.
! Please keep these operating instructions for future
reference. Pass them on to possible new owners of the
appliance.

Positioning and connection

Positioning

1. Place the appliance in a well-ventilated humidity-free
room.

2. Do not obstruct the rear fan grills. The compressor and
condenser give off heat and require good ventilation to
operate correctly and save energy.

3. Leave a space of at least 10 cm between the top part of
the appliance and any furniture above it, and at least 5 cm
between the sides and any furniture/side walls.

4. Ensure the appliance is away from any sources of heat
(direct sunlight, electric stove, etc.).

5. In order to maintain the correct distance between the
appliance and the wall behind it, fit the spacers supplied
in the installation kit, following the instructions provided.

Reversible doors

1

2

3

Levelling

1. Install the appliance on a level and rigid floor.

2. If the floor is not perfectly horizontal, adjust the
refrigerator by tightening or loosening the front feet.

Electrical connections

After the appliance has been transported, carefully place
it vertically and wait at least 3 hours before connecting it
to the electricity mains. Before inserting the plug into the
electrical socket ensure the following:

 The appliance is earthed and the plug is compliant with

the law.

 The socket can withstand the maximum power of the

appliance, which is indicated on the data plate located
on the bottom left side of the fridge (e.g. 150 W).

 The voltage must be in the range between the values

indicated on the data plate located on the bottom left
side (e.g. 220-240V).

 The socket is compatible with the plug of the appliance.

If the socket is incompatible with the plug, ask an
authorised technician to replace it (see Assistance). Do
not use extension cords or multiple sockets.

! Once the appliance has been installed, the power supply
cable and the electrical socket must be easily accessible.

! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by

authorised technicians only (see Assistance).

! The manufacturer declines any liability should these
safety measures not be observed.

4

∅ 3

5

mm

2

Description of the
appliance

Overall view

The instructions contained in this manual are applicable to different model refrigerators. The diagrams may not
directly represent the appliance purchased. For more complex features, consult the following pages.

FREEZER and

STORAGE

compartment

PURE WIND

Removable lidded
shelf

TEMPERATURE

CONTROL

GB

SHELVES

FRUIT and

VEGETABLE bin

Levelling FEET

Removable
multipurpose

SHELVES

BOTTLE shelf

 Varies by number and/or position.

3

Start-up and use

Starting the appliance

GB

! Before starting the appliance, follow the
installation instructions (see Installation).
! Before connecting the appliance, clean the

compartments and accessories well with lukewarm
water and bicarbonate.

1. Insert the plug into the socket and ensure that the
internal light illuminates.

2. Turn the TEMPERATURE ADJUSTMENT knob to an
average value. After a few hours you will be able to
put food in the refrigerator.

Setting the temperature

The temperature inside the refrigerator compartment
automatically adjusts itself according to the position of
the thermostat knob.

1 = warmest
5 = coldest

We recommend, however, a medium position.
The cooling section of the refrigerator is located inside
the back wall of the refrigerator compartment for
increased space and improved aesthetics. During
operation, the back wall will be covered in frost or water
droplets depending on whether the compressor is
operating or paused. Do not worry, the refrigerator is
functioning normally.

The back wall may be covered in frost or droplets of
water, depending on whether the compressor is in
operation or whether it is paused.
If the TEMPERATURE ADJUSTMENT knob has been set
on high values with large quantities of food and with a
high ambient temperature, the appliance can operate
continuously, resulting in excessive frost formation and
excessive energy consumption: compensate for this by
shifting the knob towards lower values (defrosting will
occur automatically).

SHELVES: with or without grill.

1

2

Due to the special guides the
shelves are removable and the
height is adjustable (see
diagram), allowing easy storage
of large containers and food.
Height can be adjusted without
complete removal of the shelf.

Using the refrigerator to its full potential

 Use the TEMPERATURE ADJUSTMENT knob to

adjust the temperature (see Description).

 Place only cold or lukewarm foods in the

compartment, not hot foods (see Precautions and
tips).

PURE WIND

It is recognizable due to the presence of the
mechanism on the top part of the refrigerator
compartment (see diagram).

B

A

Pure Wind maximises air circulation, improving the
efficiency of the evaporator and helping to achieve the
optimal temperature inside the refrigerator as quickly as
possible each time it has been opened. The blown air
(A) is cooled when it comes into contact with the cold
wall, whereas the hotter air (B) is sucked up (see
diagram).

B

A

B

 Remember that cooked foods do not last longer than

raw foods.

 Do not store liquids in open containers. They will

increase humidity in the refrigerator and cause
condensation to form.

4

Using the freezer to its full potential

 Do not re-freeze food that is defrosting or that has

already been defrosted. These foods must be
cooked and eaten (within 24 hours).

 Fresh food that needs to be frozen must not come

into contact with food that has already been
defrosted. Fresh food must be stored above the grill
in the freezer compartment and if possible be in
direct contact with the walls (side and rear), where
the temperature drops below -18°C and guarantees
rapid freezing.

 Do not place glass bottles which contain liquids, and

which are corked or hermetically sealed in the
freezer because they could break.

 The maximum quantity of food that may be frozen

daily is indicated on the plate containing the technical
properties located on the bottom left side of the
refrigerator compartment (for example: Kg/24h: 4)

! Do not open the door during freezing.

GB

! If there is a power cut or malfunction, do not open the
freezer door. This will help maintain the temperature
inside the freezer, ensuring that foods are conserved
for at least 9 -14 hours.

! If the room temperature drops below 14°C for an
extended period of time, the ideal temperature will not
be reached in the freezer compartment and food
preservation will be reduced.

5

Maintenance and care

1

2

Switching the appliance off

GB

During cleaning and maintenance it is necessary to
disconnect the appliance from the electricity supply:
It is not sufficient to set the temperature adjustment
knobs on
contact.

(appliance off) to eliminate all electrical

Cleaning the appliance

 The external and internal parts, as well as the rubber

seals may be cleaned using a sponge that has been
soaked in lukewarm water and bicarbonate of soda
or neutral soap. Do not use solvents, abrasive
products, bleach or ammonia.

 The removable accessories may be soaked in warm

water and soap or dishwashing liquid. Rinse and dry
them carefully.

 The back of the appliance may collect dust which

can be removed by delicately using the hose of a
vacuum cleaner set on medium power. The
appliance must be switched off and the plug must be
pulled out before cleaning the appliance.

Avoiding mould and unpleasant odours

discharge outlet (see diagram) where the heat
produced by the compressor causes it to evaporate. It
is necessary to clean the discharge hole regularly so
that the water can flow out easily.

Defrosting the freezer compartment

If the frost layer is greater than 5 mm, it is necessary to
defrost manually:

1. Set the TEMPERATURE ADJUSTMENT knob to the
position

2. Wrap frozen foods in newspaper and place them in
another freezer or in a cool place.

3. Leave the door open until the frost has melted
completely. This can be made easier by placing
containers with lukewarm water in the freezer
compartment.

4. Clean and dry the freezer compartment carefully
before switching the appliance on again.

5. Wait for approximately 2 hours, i.e. until the ideal
storage conditions have been restored, before
placing food in the freezer compartment.

.

 The appliance is manufactured with hygienic

materials which are odour free. In order to maintain
an odour free refrigerator and to prevent the
formation of stains, food must always be covered or
sealed properly.

 If you want to switch the appliance off for an extended

period of time, clean the inside and leave the doors
open.

Defrosting the appliance

! Follow the instructions below.
Do not use objects with sharp or pointed edges to
defrost the appliance as these may damage the
refrigeration circuit beyond repair.

Defrosting the
refrigerator
compartment

The refrigerator has an
automatic defrosting
function: water is ducted
to the back of the
appliance by a special

Replacing the light bulb

To replace the light bulb in the refrigerator
compartment, pull out the plug from the electrical
socket. Follow the instructions below.

Access the light bulb by
removing the cover as
indicated in the diagram.
Replace it with a similar
light bulb within the
power range indicated on
the cover (15W or 25W).

6