Hotpoint RFM16, RFA17, RFA16, RFM17 User Manual

FRIDGE FREEZER - MODELS RFA17, RFM17, RFA16, RFM16

INSTRUCTIONS FOR INSTALLATION & USE

GETTING STARTED:

This appliance must not be installed in a location where the room temperature

drops below 10oC, or exceeds 32oC, for prolonged periods.

To ensure that your fridge freezer runs reliably and efficiently follow these steps.

STEP 1

Choose a location for your

fridge freezer,away from

any heat sources and

allow adequate

ventilation - 100mm

(4 inch) gap above.

STEP 3

Level the fridge freezer by

adjusting the front feet. This will stop rocking or

vibration and keep the

NB.The spanner is for illustration

only and is not supplied with the

door aligned.

fridge freezer.

STEP 5

Plug in and switch on.

Allow the fridge freezer to

cool before placing food

All food in the fridge

freezer should be

inside.

covered.

STEP 2

STEP 4

STEP 6

Move the fridge freezer into position, using the sides of the cabinet. Take care to avoid damaging the refrigerant circuit pipe work on the rear.

Before plugging in and switching on, leave the fridge freezer in its final location for at least 15 minutes to allow it to settle.

Your fridge freezer is now working. If after 24 hours your fridge freezer is not operating as you want, refer to the TROUBLESHOOTING section.

INSTALLATION

SAFETY &

CONTROLS

USEFUL ADVICE

MAINTENANCE

CLEANING &

TROUBLESHOOTING

GUARANTEE

SERVICE &

Read the rest of these instructions to get the best from your appliance and

remember to fill in your guarantee registration.

Keep this Book in a safe place for quick reference.

For Your Safety

For your safety, read the following advice:

The fridge freezer cooling system contains a small amount of gas which is environmentally friendly but flammable. To avoid any risk :-

Install the fridge freezer following the installation instructions and ensure that ventilation openings are kept clear of obstruction. Take care when installing or moving the fridge freezer to avoid damaging the pipes on the rear. If you suspect a leak, do not switch on the fridge freezer,but open the windows and doors to ventilate the room.

SAFETY &

INSTALLATION

When installing your fridge freezer :-

When using your fridge freezer :-

Do not use any mechanical or electrical devices inside the fridge freezer,for instance for manual defrosting,they may cause damage. Only use this fridge freezer for storing domestic foodstuffs.

Ensure that the mains cable is not trapped underneath or behind the fridge freezer when you install or move it. Do not stack any other appliance on top of this fridge freezer as they may damage the fridge freezer or become unstable.

Do not sit or stand on top of your fridge freezer. Do not store poisonous, flammable or dangerous substances in your fridge freezer. Do not use aerosol sprays for defrosting or cleaning your fridge freezer.

If you sell the fridge freezer, pass on this booklet to the new owner.

Installation

Location & Air Circulation WARNING:This appliance must not be installed in a

100mm (4 inches)

location where the room temperature drops below 10oC, or exceeds 32oC, for prolonged periods.This is because correct storage temperatures will not be maintained. Locate your fridge freezer away from sources of heat e.g. cookers, radiators,direct sunlight as extreme temperature will affect its performance.

Allow a minimum 100mm (4 inches) between the top of the fridge freezer and the ceiling or the underside of a wall cupboard.

Providing you follow the recommended ventilation requirements you will :-

Prolong the life of the fridge freezer. Minimise the risk of condensation on the outside of the fridge freezer. Minimise the running costs. Minimise operating sounds caused by vibration.

Minimum space required to open door

The fridge freezer needs a space of 600mm (24 inches) in front to allow the door to open. When positioning the fridge freezer next to a unit, a gap of 30mm (1

/4inch) can be left at the hinge side of the door to allow the easy removal of furniture.If preferred the fridge freezer can be positioned so that a gap is not left.This will restrict how far the door can be opened but the furniture can still be removed (see diagrams below).The door hinge side can be changed to make it easier to open (see ‘Door Reversal’ in the CLEANING & MAINTENANCE section).

TOP VIEW

INSTALLATION

SAFETY &

600mm

30mm or more

600mm

less than 30mm

Installation

Levelling:

Level the fridge freezer when it is in its final location by adjusting the front feet, until firm contact is made with the floor. This will stop rocking or vibration and keep the doors aligned which helps the fridge freezer run reliably and efficiently.

Note: Before plugging in and switching on,leave the fridge freezer standing in its final location for at least 15 minutes to allow it to settle.

WARNING:Failure to level the appliance correctly may result in misalignment

of the cabinet and/or doors.

SAFETY &

INSTALLATION

Defrost Tube:

A tube is supplied to help feed defrost water into a collecting vessel,ie. a bowl (see ‘Defrosting’in the CLEANING & MAINTENANCE section). For safe keeping until required, the tube can be stored in the floor of the freezer compartment.

Defrost tube in storage position

Floor of the freezer compartment

Installation

Electrical Supply

WARNING:This appliance must be earthed.

The appliance must be positioned so that the plug is accessible after installation.

Fuses

Your appliance comes fitted with a plug and a 13A fuse. If you need to replace the fuse, only use those rated at 13A and ASTA approved to BS1362.

Changing the Plug

Cut off and dispose of the supplied plug if it does not fit your socket.

WARNING:To avoid a shock hazard do not insert the discarded plug into a socket anywhere else.

IMPORTANT WIRES IN THE MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE :

Green/Yellow - Earth

INSTALLATION

SAFETY &

Blue - Neutral Brown - Live

If you change the plug, the colour of wires in the mains lead may not correspond with the colour of the markings identifying terminals in the plug. You should therefore wire it as shown above.

Changing the Mains Lead

This appliance is fitted with a special mains lead. If you need to replace the mains lead due to damage, one can be bought from Hotpoint Service (see KEY CONTACTS, back page). It is strongly advised that this work is carried out by a qualified electrician.

CE Marking certifies that this appliance conforms to the following EEC directives : Low Voltage Equipment - 72/23/EEC & 93/68 EEC Electromagnetic Compatibility 89/336/EEC, 92/31/EEC & 93/68/EEC

Controls

Controlling the Temperature of the Fridge Compartment

The control wheel on the front of the worktop adjusts the internal fridge compartment temperature. The internal temperature should be 5˚C or colder, although some sections such as the salad bin will be slightly warmer. The setting of the control wheel will depend on the location of the appliance,the room temperature and how often the doors are opened. The normal set point (marked by a 3 and N on the dial) is usually suitable. If you need to adjust the temperature turn the control wheel:

Clockwise (higher number) - Colder Anti-clockwise (lower number) - Warmer

Temperature Indicator

(not applicable to all models)

The temperature indicator is located on the bottom right

CONTROLS

After plugging in and switching on PLEASE WAIT 24 HOURS for the fridge compartment temperature to stabilise.After this time the indicator should clearly show OK and that indicates the fridge compartment is operating at the correct temperature.

hand side of the fridge compartment wall. This indicator shows when the fridge compartment of your fridge freezer is operating at the correct temperature.

If the indicator is completely black, the compartment temperature is too high and you should adjust the control wheel to a colder setting (see above).

If you have to adjust the temperature setting please WAIT A MINIMUM OF 10 HOURS, this is time for the temperature to stabilise before checking that the indicator is showing OK. If large quantities of food have been added or if the fridge compartment door has been opened frequently it is normal for the temperature indicator not to show OK. WAIT A MINIMUM OF 10 HOURS before adjusting the temperature to a colder setting.

Controlling the Temperature of the Freezer Compartment

With a suitable fridge compartment temperature, the freezer compartment will automatically be maintained at the correct temperature (below -18˚C).

You can check the temperature of the fridge freezer compartments by using a Fridge Freezer Thermometer available from Hotpoint Genuine Parts and Accessories Mail Order Hotline (see KEY CONTACTS back page).

WARNING: Do not use a mercury filled thermometer,as breakage would cause a health hazard.

Useful Advice

Note: The Rating Plate, which lists the appliance Model Number and Serial Number can be found near the bottom of the freezer compartment on the interior wall.

C D

Fast Freeze

Note: The photographs indicate the Fast Freeze and storage areas (see tables). The fridge cabinet and door furniture will vary according to each model specifications.

Fast Freeze

USEFUL ADVICE

Useful Advice

Making the best use of your Fridge Freezer

Note : Always use the handle provided to open the fridge / freezer door.

To ensure that your fridge freezer operates as efficiently as possible :

Follow food packaging “best before/use by” instructions or your suppliers advice on a suitable maximum storage time. Keep foods tightly covered to retain moisture and prevent flavour/odour transference. Plastic bags, aluminium foil,plastic stretch wrap and containers with lids are ideal. Select chilled and frozen food last when shopping,transport in a ‘cool bag’ and place in freezer as soon as possible after arriving home. Avoid opening the doors unnecessarily or for longer than needed. Allow hot or warm food to cool down in covered containers before placing in the fridge or freezer, as placing hot food inside reduces efficiency. Prepare fresh foods for freezing in small quantities to ensure that the food freezes quickly and so that its quality does not deteriorate. Ensure that packets/containers of food are dry before freezing otherwise they may freeze together.

Storing Food in a Fridge

Pack and store cooked and fresh food separately. Wrap raw or defrosting meat and poultry in polythene or foil and store below cooked foods and dairy products to avoid contamination of dripping food juices. Wrap cheese in greaseproof paper and place in an airtight container or polythene bag. Bring to room temperature before consuming. Empty left over canned food into a covered storage containers before

USEFUL ADVICE

placing in the fridge. Position food to allow cold air to circulate freely, ensuring nothing comes into contact with the back of the fridge compartment, or covers the defrost gutter drain hole below this. Use the different storage zones inside your fridge compartment to store a wide variety of food items.

STORAGE ZONES

Zone Type Food Storage

A Cool Dairy products, Cheese, butter,margarine,

B Colder General food storage

C Coldest Meat fish & poultry

D Salad Bins Vegetables,fruit and salad items

Low fat spreads,cooking fats / lards Preserves - Jam, curd,marmalade, spread,salad dressing or sauces.

Pre-cooked / chilled food

(Not recommended for the storage of bananas or onions).

+ 16 hidden pages