Hotpoint KSOS 89 PX Operating Instructions Manual

SY89PG
SE89PG X
SE89PG
SH89PX
KSOS 89 PX

GB

OVEN

Contents

Warnings, 2

Installation, 3

Positioning

Electrical connection, 4

Data plate

Description of the appliance, 5

Overall view
Control panel
Display

Start-up and use, 6

Setting the clock
Setting the timer
Starting the oven

Cooking modes, 7-9

Cooking modes
Programming cooking
Practical cooking advice
Cooking advice table

Precautions and tips, 10

General safety
Disposal
Respecting and conserving the environment

Care and maintenance, 11-13

Switching the appliance off
Cleaning the appliance
Cleaning the oven door
Replacing the light bulb
Automatic cleaning using the FAST CLEAN function
Assistance

Guarantee, 14

After Sales Service, 15

English, 1

Operating Instructions

GB

2

GB

Warnings

WARNING: The appliance and its accessible parts become hot during use.
Care should be taken to avoid touching heating elements. Children less than
8 years of age shall be kept away unless continuously supervised. This
appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.

Do not use harsh abrasive cleaners or sharp metal scrapers to clean the
oven door glass since they can scratch the surface, which may result in
shattering of the glass.

Never use steam cleaners or pressure cleaners on the appliance.

WARNING: Ensure that the appliance is switched off before replacing the
lamp to avoid the possibility of electric shock.

Before initiating the automatic cleaning cycle:

• clean the oven door;

• remove large or coarse food residues from the inside of the oven using a
damp sponge. Do not use detergents;

• remove all accessories and the sliding rack kit (where present);

• do not place tea towels

Keep children away from the appliance during the automatic cleaning cycle
as surfaces may become very hot.

3

GB

Ventilation

To ensure adequate ventilation is provided, the back
panel of the cabinet must be removed. It is
advisable to install the oven so that it rests on two
strips of wood, or on a completely flat surface with
an opening of at least 45 x 560 mm (

see diagrams

).

Centring and fixing

Position the 4 tabs on the side of the oven, in line
with the 4 holes on the outer frame. Adjust the tabs
according to the thickness of the cabinet side panel,
as shown below:

20 mm thick: take off the
removable part of the tab
(

see diagram

).

18 mm thick: use the first
groove, which has already
been set in the factory
(

see diagram

).

16 mm thick: use the second
groove (

see diagram

).

Secure the appliance to the cabinet by opening the
oven door and inserting 4 screws into the 4 holes on
the outer frame.

!!

!!

! All parts which ensure the safe operation of the

appliance must not be removable without the aid of
a tool.

!!

!!

! Before operating your new appliance please read

this instruction booklet carefully. It contains
important information concerning the safe operation,
installation and maintenance of the appliance.

! Please keep these operating instructions for future
reference. Pass them on to possible new owners of
the appliance.

Positioning

!!

!!

! Keep packaging material out of the reach of

children.
It can become a choking or suffocation hazard. (

see

Precautions and tips

).

!!

!!

! The appliance must be installed by a qualified

professional in accordance with the instructions
provided. Incorrect installation may cause harm to
people and animals or may damage property.

Built-in appliance

Use the appropriate cabinet to ensure that the
appliance functions properly.

• The panels adjacent to the oven must be made of
heat-resistant material.

• Cabinets with a veneer exterior must be
assembled with glues which can withstand
temperatures of up to 100°C.

• to install the oven under the counter (

see diagram

)
or in a kitchen unit, the cabinet must have the
following dimensions:

!!

!!

! The appliance must not come into contact with

electrical parts once it has been installed.
The indications for consumption given on the data
plate have been calculated for this type of
installation.

595 mm.

595 mm.

24 mm.

545 mm.

5 mm.

567 mm.

23 mm.

575-585 mm.

45 mm.

560 mm.

547 mm. min.

Installation

560 mm.

4

5

m

m

.

4

GB

TABLE OF CHARACTERISTICS

Dimensions

width 43.5 cm
height 32 cm
depth 40 cm

Volume

56 l

Dimensions *

width 43.5 cm
height 32 cm
depth 41.5 cm

Volume *

58 l

Electrical
connections

voltage: 220 - 240 V~ 50/60Hz
maximum power absorbed 2800 W
(see data plate)

ENERGY
LABEL

Directive 2002/40/EC on the label of
electric ovens. Standard EN 50304

Energy consumption for Natural
convection – heating mode:
Traditional mode

Declared energy consumption for
Forced convection Class – heating
mode: Baking

This appliance conforms to the
following European Economic
Community directives: 2006/95/EEC
dated 12/12/06 (Low Voltage) and
subsequent amendments –
2004/108/EEC dated 15/12/04
(Electromagnetic Compatibility) and
subsequent amendments ­93/68/EEC dated 22/07/93 and
subsequent amendments.
2002/96/EC and subsequent
amendments.
1275/2008 stand-by/off mode

* With glass panel fitted to the inside of the door

Electrical Connection

Electrical connection

The electrical connection to the mains must be made
on the appliance. The power voltage and frequency
are as indicated on the rating plate.

!

THIS APPLIANCE MUST BE EARTHED.THIS APPLIANCE MUST BE EARTHED.

THIS APPLIANCE MUST BE EARTHED.THIS APPLIANCE MUST BE EARTHED.

THIS APPLIANCE MUST BE EARTHED.

Connecting the power supply cable

To open the terminal board:

• Using a screwdriver, press on the tabs situated

on each side of the terminal board cover.

• Pull open the terminal board cover.

To connect the power supply cable, proceed as
follows:

••

••

• Unscrew the cable clamp screw and the contact

screws L-N-.

• Fasten the wires beneath the screwheads using

the following colour scheme: Blue (N) Brown (L)

Yellow-Green



• Fasten the power supply cable in the

corresponding cable clamp and close the cover.

Electrical Connection:

Voltage Frequency: 230
V-1+N 50Hz
Fuse Section: 16A
Supply cable:
3x1.5mm

2

You can connect your oven to the system means of
a terminal board. Refer to above information for the
minimal cable sections and the calibration of the
protective elements according to the connection.
If the appliance is installed with a junction box, an
omnipolar circuit breaker - with a minimum contact
opening of 3mm - should be installed between the
appliance and the mains.

Power cable supply connection to the electrical
mains:

We recommend you use a power supply cable which
is long enough to allow you to take the oven out of
its recess in the event of maintenance operations
(only use HAR - H 05 - RRF quality cables fitted with

a plug conforming to the regulations in force.
The plug must be accessible at all times.

Unplug the appliance before all operations, even
when replacing the oven lamp.

Using the appliance without correct earthing is
highly dangerous.
! After connecting the appliance to the flexible
cable, tighten all the screws on the terminal
board.

! The cable must be checked regularly and replaced
by authorised technicians only (

see Assistance

).

!

The manufacturer declines any liability shouldThe manufacturer declines any liability should

The manufacturer declines any liability shouldThe manufacturer declines any liability should

The manufacturer declines any liability should

these safety measures not be observed.these safety measures not be observed.

these safety measures not be observed.these safety measures not be observed.

these safety measures not be observed.

42
NL

5

GB

Control panel

GRILL

DRIPPING PAN

GUIDES for the

sliding racks

position 5

position 4
position 3
position 2
position 1

Description
of the appliance

Overall view

Control panel

Display

SELECTOR
Knob

THERMOSTAT

knob

DISPLAY

TIME SETTING

button

FAST CLEAN

button

TIMER
knob

TEMPERATURE
and TIME digits

END OF COOKING
icon

CLOCK
icon

DURATION
icon

TIMER

icon

STOP

icon

Preheating

indicator

DOOR LOCK

indicator