HOTPOINT HZ A1.UK.1 Daily Reference Guide

HOTPOINT HZ A1.UK.1 Daily Reference Guide

 

 

EN

Quick guide

 

 

 

 

THANK YOU FOR BUYING A HOTPOINT PRODUCT

In order to receive a more complete assistance, please register your product on www.hotpoint.eu/register

Before using the appliance carefully read the Safety Instruction.

FIRST TIME USE

Wait at least two hours, after the installation, before connecting the appliance to the power supply.

Connect the appliance to the power supply and turn the thermostat knob to switch on the appliance.

After turning the appliance on, you must wait for 4-6 hours for the correct storage temperature to be reached for a normally filled appliance. Position the antibacterial anti-odour filter in the fan as demonstrated in the filter packaging (if available).

CONTROL PANEL

 

 

 

 

 

 

 

 

 

 

 

 

1.

Temperature control lamp (Red Alarm

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2.

light)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Operation Control lamp (Green light)

 

 

 

 

 

 

 

 

 

 

 

 

3.

Open door alarm switch

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1.

 

 

2.

 

3.

4.

4.

Temperature control knob (thermostat)

TEMPERATURE & OPERATION CONTROL LAMP (GREEN & RED LIGHT)

Please check that the voltage indicated on the rating plate situated inside the compartment corresponds to the voltage in your home. The earthing of this appliace is compulsory by law. The manufacturer will accept no liability for injury to persons or damage to objects arising from the non observance of this requirement.

When theappliance is plugged in, if the thermostat knob is not set to symbol , the green and the red lamps (points 1 and 2 control panel) light up. The green control light always remains alight and indicates the operation of the appliance. The red control light remains alight until the set operation temperature has been attained. It lights up again when the temperature inside the freezer rises due to frequent or prolonged door opening, and when the appliance has been loaded with fresh food to be frozen.

OPEN DOOR ALARM SWITCH

This appliance is equipped with an acoustic alarm which sounds when the door is left open.

TEMPERATURE CONTROL KNOB (THERMOSTAT)

The thermostatcontrols the temperature inside the appliance. Position indicates that the operation of appliance is interrupted. In normal ambient conditions (temperature between +20°C and

+25°C), we suggest you adjust the thermostat control knob to a middle position. To obtain colder or warmer temperatures than -18°C, turn the thermostat control knob to the highest or lowest setting respectively.

We remind you that internal temperatures are affected by the location of the appliance, the temperature of the surrounding air, the frequency of the door opening. The setting of the thermostat may have to be varied to allow for these factors. To check the temperature of the food stored, place the thermometer (if delivered) under the food; if it is placed on the food it will indicate the temperature of the air which does not correspond to that of the food stored.

Recommended setting:

Freezer compartment: MEDIUM

To avoid food waste, please refer to the recommended setting and storage times found in the online user manual.

HOW TO STORE FRESH FOOD

Legend

FREEZER DRAWERS

FREEZING ZONE DRAWER

(Max cool zone)

Suggested to freeze fresh/cooked food

* Available only on certain models

FREEZER COMPARTMENT

Freezing fresh food

1.It is advisable to set the temperature colder or turn on the Fast Freeze/ Fast Cool* at least four hours before removing the food from the freezer compartment, to prolong the preservation of the food during the defrosting phase.

2.To defrost, unplug the appliance and remove the drawers. Leave the door open to allow the frost to melt. To prevent the water from

escaping during the defrost, it is advised that you place an absorbent cloth on the bottom of the freezer compartment and wring it out regularly.

3.Clean the inside of the freezer compartment and dry it carefully.

Light system (depending on model)

This product contains a light source of energy efficiency class G

This product contains a light source of energy efficiency class G

GENERAL INFORMATION

4.Turn the appliance back on and put the food back inside. To remove the frost on the STOP FROST* accessory, follow the CLEANING.

Ice cubes*

Fill 2/3 of the ice tray with water and put it back in the freezer compartment. Do not, under any circumstances, use sharp or pointed objects to remove the ice.

The quantity of fresh food that can be frozen in a specific time period is indicated on the rating plate.

Load limits are determined by baskets, flaps, drawers, shelves etc. Make sure that these components can still close easily after loading.

This product contains 4 lateral light sources of energy efficiency class A

This product contains 4 lateral light sources of energy efficiency class A and a top light source of energy class G

This product contains a top light source of energy efficiency class G

The drawers, baskets and shelves should be kept in their current position unless otherwise specified in this quick guide. The light system inside the refrigerator compartment uses LED lights, allowing for better lighting than with traditional light bulbs, as well as for very low energy consumption.

Doors and lids of the refrigeration appliance should be removed before disposal in the landfill, to avoid children or animals getting trapped inside.

* Available only on certain models

Loading...
+ 2 hidden pages