Hotpoint HTC95 Instruction Manual

COOKER HOOD

USER HANDBOOK FOR

INSTALLATION AND OPERATION

MODELS HTC95

Your new Cooker Hood

Using your new Cooker Hood is very simple. Nevertheless, to get the best results it is
important that you read this handbook thoroughly before installing and using your
appliance for the first time.

Electrical Requirements

Any permanent electrical installation must comply with the latest I.E.E. Regulations and
local electricity company regulations. For your own safety, this should be undertaken by a
qualified electrician eg. your local electricity company or a contractor who is on the roll of
the National Inspection Council for Electrical Installation Contracting (NICEIC).

Please ensure that when the appliance is installed it is easily accessible for the engineer
in the event of a breakdown.

INCORRECT INSTALLATION COULD AFFECT THE SAFETY OF THE APPLIANCE

If the Cooker Hood is permanently wired in, it must be via a suitable double pole isolating
switch placed in a readily accessible position adjacent to the unit.

Electrical Connection

Before connecting to the mains supply ensure that the mains voltage corresponds to the
voltage on the rating plate,inside the Cooker Hood.

WARNING:THIS APPLIANCE MUST BE EARTHED!

It is fitted with a 2 core mains supply cable and must be permanently connected to the
electricity supply via a double pole switch having 3mm minimum contact gap on each
pole. A Switched Fuse Connection Unit to BS 1363 Part 4,is a recommended mains supply
connection accessory to ensure compliance with the Safety Requirements applicable to
fixed wiring instructions.

DISCONNECT THE COOKER HOOD FROM THE MAINS SUPPLY BEFORE CARRYING OUT ANY
KIND OF MAINTENANCE OR CLEANING.

WARNING:
CHILDREN SHOULD NOT BE ALLOWED TO PLAY WITH THE APPLIANCE OR TAMPER WITH
THE CONTROLS.

CE marking certifies that this appliance conforms to the following EEC directives:­Low Voltage Equipment - 72/23/EEC
Electromagnetic Compatibility - 89/336/EEC

2

Contents

Page

Electrical Requirements 2
Get to know your Cooker Hood 4
Installing your Cooker Hood 5-8
Operating your Cooker Hood 9

The Controls
Do’s and Don’ts

Caring for your Cooker Hood 10

Filters and their Replacement
Cleaning
How to Replace the Light

Troubleshooting 11
Key Contacts Back Cover

Appliance manufactured in EU.

Retention of the Instruction Book

This Instruction Book must be kept handy for reference as it contains important details on the
safe and proper use of the appliance.

If you sell or pass the appliance to someone else,or move house and leave it behind,make sure
this Book is also provided so the new owner can become familiar with the appliance and safety
warnings.

If the book is lost or damaged a copy may be obtained from:
GDA Ltd.,Morley Way, Peterborough,PE2 9JB

3

Get to know your Cooker Hood.

Unpacking - This is a two person operation.

Before installation, ensure that you have removed all packing pieces.
Ensure the fixing kit, ducting spigots and literature pack are retained with the hood.

Chimney Section

Glass Visor

Controls

Worktop Lighting

Filter Grille

Performance Table

No.of speeds Pressure Pa Capacity (m3/h) Noise Level

MIN MAX MIN MAX

3 360 225 600 45 68

Dimensions of your Cooker Hood

Height adjustable from: 660mm to 965mm
Width 900mm
Depth 500mm

All measurements are in millimetres.

298

298

Min 660
Max 965

468

900

500

4