Quick guide
EN
THANK YOU FOR BUYING A HOTPOINT PRODUCT
In order to receive a more complete assistance, please
register your product on www . hotpoint . eu/ register
FIRST TIME USE
Wait at least two hours, after the installation, before connecting
the appliance to the power supply. Connect the appliance to the
power supply it starts the operation automatically. The ideal storage
temperatures for the food are preset in the factory.
CONTROL PANEL
2.
1.
3.
ON/STANDBY
Press the button for 3 seconds to turn the appliance o. In
Stand-by mode the light in the refrigerator compartment does not turn
on. Press the button again briey to reactivate the appliance.
Note: this does not disconnect the appliance from the power supply.
FREEZER AND REFRIGERATOR
COMPARTMENT TEMPERATURE
The three LED indicators indicate the refrigerator compartment set
temperature.
It is possible to set a dierent temperature of the appliance with the
button.
The following adjustments are possible:
LEDs lit Set temperature
Before using the appliance carefully read the Safety
Instruction.
After turning the appliance on, you must wait for 4-6 hours for the
correct storage temperature to be reached for a normally lled
appliance. Position the antibacterial anti-odour lter in the fan as
demonstrated in the lter packaging (if available). If the audible signal
sounds, it means that the temperature alarm has intervened: press the
button to switch o the acoustic alarms.
1. LED Light
2. On/Stand-by
3. Freezer and refrigerator compartment
temperature button
FAST COOL FUNCTION FAST COOLING
To quickly cool the refrigerator compartment, or
6 hours before putting a large quantity of food
to be frozen in the freezer compartment, turn
on the “Fast Cooling” function by repeatedly
pressing the
green and then stay constant.
The function automatically turns o after 30 hours and the
temperature returns to the previous setting when the function is
turned on.
To turn the function o manually, press the button.
Note: avoid a direct contact between the fresh food and the food that is
already frozen.
To optimize the freezing speed, the lower drawer can be removed and
the food can be placed directly on the bottom of the compartment.
button until the 3 icons ash
High (less cold)
Medium-high
Medium
Medium-low
Low (colder)
Fast cool
Recommended setting:
• Refrigerator compartment: MEDIUM
To avoid food waste, please refer to the recommended setting and storage
times found in the online user manual.
* Available only on certain models
HOW TO STORE FRESH FOOD AND BEVERAGES
** For models
with "0 ° ZONE"
COMPARTMENT
the "coolest
area" is the one
highlighted in
the legend
REFRIGERATOR COMPARTMENT
Fan*
The Fan is pre-set to ON. You can turn the Fan on/o by pressing the
light button (as shown in gure 2) and at the same time the button
as shown in gure 3. The light will ash just once if the Fan is OFF, or it
will ash 3 times if the Fan in ON. If the ambient temperature exceeds
27°C, or if drops of water are present on the glass shelves, it is essential
that the fan is on to ensure the proper preservation of the food.
*
**
Legend
TEMPERATE ZONE
Suggested for storage of tropical fruit, cans, drink, eggs,
sauces, pickles, butter, jam
COOL ZONE
Suggested for storage of cheese, milk, daily food,
delicatessen, yoghurt
COOLEST AREA
Suggested for storage of cold cuts, desserts, meat and
sh
FRUIT & VEGETABLE DRAWER
Deactivation of the fan allows energy consumption to be optimised.
1 2 3
Light system (depending on model)
This product contains a light source of energy
eciency class G
This product contains a light source of energy
eciency class G
FREEZER COMPARTMENT
Freezing fresh food
1. It is advisable to set the temperature colder or turn on the Fast Freeze/
Fast Cool* at least four hours before removing the food from the
freezer compartment, to prolong the preservation of the food during
the defrosting phase.
2. To defrost, unplug the appliance and remove the drawers. Leave
the door open to allow the frost to melt. To prevent the water from
escaping during the defrost, it is advised that you place an absorbent
cloth on the bottom of the freezer compartment and wring it out
regularly.
3. Clean the inside of the freezer compartment and dry it carefully.
This product contains 4 lateral light sources of
energy eciency class A
This product contains 4 lateral light sources of
energy eciency class A and a top light source
of energy class G
This product contains a top light source of
energy eciency class G
4. Turn the appliance back on and put the food back inside. To remove
the frost on the STOP FROST* accessory, follow the CLEANING.
Ice cubes*
Fill 2/3 of the ice tray with water and put it back in the freezer
compartment. Do not, under any circumstances, use sharp or pointed
objects to remove the ice.
The quantity of fresh food that can be frozen in a specic time period is
indicated on the rating plate.
Load limits are determined by baskets, aps, drawers, shelves etc. Make
sure that these components can still close easily after loading.
GENERAL INFORMATION
The drawers, baskets and shelves should be kept in their current position
unless otherwise specied in this quick guide. The light system inside the
refrigerator compartment uses LED lights, allowing for better lighting than
with traditional light bulbs, as well as for very low energy consumption.
* Available only on certain models
Doors and lids of the refrigeration appliance should be removed before
disposal in the landll, to avoid children or animals getting trapped inside.
Loading...