DAILY REFERENCE
GUIDE
EN
THANK YOU FOR PURCHASING AN HOTPOINT PRODUCT
To receive more comprehensive help and support, please register your product at www.hotpoint.eu/register
You can download the Safety Instructions and WWW the Use and Care Guide by visiting our website
docs.hotpoint.eu and following the instructions on the back of this booklet.
Before using the appliance carefully read the Health and Safety guide.
PRODUCT DESCRIPTION
APPLIANCE |
|
2 |
|
3 |
|
4 |
|
5 |
|
6 |
|
7 |
|
8 |
|
9 |
|
16 |
|
17 |
18 |
19 |
|
10
11
12
13
14
1
15
Refrigerator compartment
1.Dispenser’s paddle
2.Fan
3.Electronic control panel / light unit
4.Shelves
5.Rating plate with commercial name
6.Fresh crisper
7.Humidity control
8.Fridge drawer divider
9.Door reversibility kit
10.Egg tray
11.Door trays
12.Water filter
13.Aqua balcony
14.Aqua tank
15.Door seal
Freezer compartment
15.Door seal
16.Freezer drawers
17.Shelves
18.Easy ice
19.Bottom drawer: coolest zone best for freezing fresh food
CONTROL PANEL
1
2
1.Indicator Leds (to display the current temperature setpoint or the Super Cool function)
2.Super Cool button / Temperature button
1
ACCESSORIES
EGG TRAY |
BOTTLE HOLDER |
ICE TRAY |
FIRST TIME USE
HOW TO START THE APPLIANCE
After plugging the appliance to the mains, it starts the operation automatically. After starting the appliance, wait at least 4-6 hours before placing food into the fridge and into the freezer compartment.
When the appliance is connected to the power supply, the display lights up and all the icons appear on the display for approximately 1 second. The default (factory) values of the fridge compartment settings light-up.
DAILY USE |
page for information on how to obtain the Use and Care Guide |
|
See Use and Care Guide for more details on functions / see last |
FUNCTIONS
TEMPERATURE SETTING
Press the Temperature button on the control panel to adjust the temperature from the warmest through the lower to the coldest level.
Pressing the Temperature button, the temperature setting will change cyclically. At first plug-in of appliance
temperature setpoint is present at medium position (factory setting).
Following table shows temperature setpoints:
HIGH TEMP.
MED-HIGH TEMP.
MEDIUM TEMP.
MED-LOW TEMP.
LOW TEMP.
SUPER COOL
Led on
Led off
Note: Displayed set points correspond to the average temperature throughout the whole refrigerator.
SUPER COOL
The use of the Super Cool function is recommended to increase the cooling capacity of the refrigerator
compartment when placing a very high quantity of food within it.
To activate the Super Cool function, press and hold for 3 seconds the Temperature button on the control panel till all the 3 LEDs will turn on.
The function is automatically deactivated after 24 hours and return to previous selected set point.
The function can be manually deactivated by pressing and holding for 3 seconds the Temperature button on the control panel.
REFRIGERATOR LIGHT
The light system inside the refrigerator compartment uses LEDs light,
allowing a better lightning as well as a very low energy consumption.
If the LED light system does not work, please contact the Service to replace it.
Important: The refrigerator compartment light switches on when the refrigerator door is opened. If the door is kept open for more then 8 minutes the light will be automatically switched off.
FAN
The Fan improves temperature distribution inside the refrigerator compartment, allowing better preservation of stored food.
By default, the fan is switched on.
To turn off the fan press the button of fan.
Please note that when the fan is switched on it will not continuously work. The fan will start/stop working depending on the temperature and/or humidity level inside the fridge.
It is therefore absolutely normal if the fan does not move even if the fan is switched on.
ALARM TABLE
ALARM TYPE |
SIGNAL |
CAUSE |
CURE |
Door open alarm |
Refrigerator Light blinks |
The door has remained open |
Close the door |
|
|
for more than 5 minutes. |
|
Door open alarm |
Refrigerator Light OFF |
The door has remained open |
Close the door |
|
|
for more than 8 minutes. |
|
Malfunction |
Any temperature indicators |
Product malfunction. |
Contact the After-sales Service |
|
blinks |
|
|
|
|
|
|
2 |
|
|
|
EN
SOME OF THE FUNCTIONAL SOUNDS YOU MIGHT HEAR
A hissing sound when switching on the appliance for the first time or after a long pause.
Buzzing sound when water valve or fan start working.
A gurgling sound when refrigerant fluid enters into the pipes.
A cracking sound when compressor starts.
BRRR sound is from the compressor running.
The CLICK is from the thermostat which adjusts how often the compressor is running.
DAILY USE
See Use and Care Guide for more details on functions / see last page for information on how to obtain the Use and Care Guide
INSTALLATION OF THE WATER FILTER (ACTIVE CARBON)
The water filter is located inside the tank. This filter reduces the amount of chlorine, sediment, dirt, rust and cloudiness in the drinking water in the container located inside the tank. The filter must be installed in bottle balcony following the instructions contained in the water filter box. The filter is removable.
3