HOTPOINT FTVF NW 85C GG (UK) User Manual

Instruction booklet

GB

English

FTVF NW 85

TUMBLE DRYER

This symbol reminds you to read this booklet.

!Keep this instruction booklet on hand in order to refer to it when necessary. Take it with you when you move, and should you sell this appliance or pass it on to another party, make sure that this booklet is supplied along with the dryer so that the new owner may be informed about warnings and suggestions on how the appliance works.

!Read these instructions carefully; the following pages contain important information on installation and suggestions on how the appliance works.

Contents	GB

Installation, 2-3

Where to put your dryer

Ventilation

Electrical connection

Levelling

Before you start using your dryer

Warnings, 4-5

General safety

To minimise the risk of fire

Maintenance and Care, 6

Switching off the electricity

Cleaning the filter after each cycle

Check the drum after each cycle

Cleaning the dryer

Dryer description, 7

The features

Control panel

Choosing a programme

The Display, 8

Start and programmes, 9-13

The Controls

Programmes Table

Laundry, 14

Sorting your laundry

Wash care labels

Drying times

Troubleshooting, 15

Service, 16

Spare Parts

Product data, 17

Recycling and Disposal

To activate your free* 5 Year Parts Guarantee Call free on 0800 519 2102

*Labour charges not included. Terms and consitions apply. Lines open 364 days a year. Calls are free from a BT landline. Charges from other providers and mobiles may apply.

www.hotpoint.co.uk

1

Installation

Where to put your dryer

GB

●Place your dryer at a distance from gas ranges, stoves, heaters, or cook tops because flames can damage the

Minimum gap 10mm		appliance.
	●	If you are going to
		install the appliance
		under a work counter,
		be sure to leave a
		10mm space between
Minimum gaps		the top and any other
15mm		objects on or above
		the machine and a

15mm space between the sides and lateral furnishings or walls. This is to ensure proper air circulation. Make sure that the back vents are not obstructed.

●Make sure you put your dryer in an environment that is not damp and has proper air circulation throughout, the dryer will not operate efficiently in an enclosed space or cupboard.

!We do not recommend that the dryer is installed in a cupboard but the dryer must never be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the dryer door.

!The appliance must be installed with the rear surface placed against a wall.

Ventilation

The Dryer dries your laundry by drawing in cool, clean and relatively dry air, heating it, and then distributing it through the clothes as they are gently tumbled. For optimum performance, the moist air is then blown out through a vent tube at the back of the dryer.

When the dryer is in use, there has to be adequate ventilation to avoid the back flow of gases into the room from appliances burning other fuels, including open fires.

Mobile venting

A vent tube must always be fitted when the dryer is used in conjunction with Mobile Venting.

The tube must be fitted securely into the back of the dryer (see Dryer Description). If possible, it is always best to connect the tube to a permanent

outlet close to the dryer. If permanent installation is not possible, the dryer will work just as well with the tube passing through a partly-opened window.

!Ensure that the end of the tube is not directed toward the air intake vent at the rear of the dryer.

!The vent tube should not exceed 2.4 metres in length and should be kept free of any possible accumulation of fluff, lint and water by shaking it out frequently. Always ensure that the tube is not squashed.

Permanent venting

In conjunction with the vent tube we recommend using a Wall/Window Vent Kit, available at a retail location or the nearest Spare Parts Dealer.

Wall mounting

1. Leave an opening in the wall to the left of the dryers proposed position. 2. Keep the tube as short and straight as possible to prevent condensed moisture from backing up into the dryer.

3. Similarly, the duct in the wall should slope downwards towards the outside.

Window mounting

1. With a stacked dryer the hole in the window should ideally be made below the vent.

2. The tube should be kept as short as possible.

Depending on how often you use your dryer, it is essential that areas A and B are checked periodically to remove lint or debris.

The vent tube adaptor must be fitted securely thus preventing any humid air from being emitted back into the room.

!The Dryer should not be pushed so far back that the tube adaptor is pulled out of position or the tube is squashed or bent.

!The tube should be kept clear of the air intake vent and kinks or ‘U’ bends must be avoided as these will obstruct the tube or trap condensation.

2

Installation

Open window venting

The end of the tube should be directed downwards, to prevent warm moist air from condensing in the room or in the dryer.

!Ensure that the dryer is adequately ventilated and that the end of the vent tube is not directed towards the air intake duct.

!The vent tube must always be fitted for optimum performance.

!Make sure that the vent tube and air intake vents are not obstructed or blocked.

!The dryer must not recycle exhaust air.

!Misusing a tumble dryer may create a fire hazard.

!Do not discharge exhaust air into a flue which is used for exhaust fumes from other appliances that burn gas or other fuels.

!Do not discharge exhaust air into an extraction system or any duct with an extractor fan. This will affect the way the thermal controls operate and can result in a fire hazard.

! Do not use extension cords.

GB

!The power cord must not be bent or squashed.

!The power cord should be regularly checked. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. New or longer power cords are supplied at an extra charge by authorised dealers..

!The manufacturer denies any responsibility should any of these rules not be followed.

!If in doubt about any of the above consult a qualified electrician.

Levelling your dryer

The dryer must be installed level for correct operation.

When you have installed your dryer in its final location check that it is level first side to side, then front to back.

Electrical connections

Make sure of the following before you insert the plug into the the electrical socket:

●Make sure your hands are dry.

●The socket must have an earth connection.

●The socket must be able to sustain the machines maximum power, which is indicated on the rating label (see Dryer

Description).

●Power voltage must be within the values indicated on the rating label (see Dryer Description).

●The socket must be compatible with the dryers plug. Should this not be the case, replace the plug or the socket.

!The dryer must not be installed outdoors, even if the space is sheltered. It can be very dangerous if it is exposed to rain or storms.

!Once installed, the dryers electrical wire and plug must be within easy reach.

If the dryer is not level, use a wooden block to support it while adjusting the two front legs up or down, until your dryer is level.

Before you start using your dryer

Once you have installed your dryer and before you use it, clean the inside of the drum to remove any dust that could have accumulated during transport.

Maximum load

Natural fibres : 8 kg

3

Warnings

GB	! The appliance has been designed and
	built according to international safety
	standards.
	These warnings are given for safety
	reasons and must be followed carefully.

General safety

●This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities, or lack of knowledge if they are given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

●This tumble dryer has been designed for home, and not professional use.

●Do not touch the appliance while bare foot or with wet hands or feet.

●Unplug the machine by pulling on the plug, not the cord.

●After using the dryer, turn it off and unplug it. Keep the door closed to make sure that children do not use it as a toy.

●Children should be supervised to ensure that they do not play with the dryer.

●Cleaning and user maintenance should not be made by children without supervision.

●Children of less than 3 years should be kept away from the appliance unless continuously supervised.

●The appliance must be installed correctly and have proper ventilation. The air intake vents behind the machine, the outlet vents and the vent tube should never be obstructed (see Installation).

●Never direct the vent tube outlet towards the air intake at the back of the machine.

●Never allow the tumble dryer to recycle exhaust air.

●Never use the dryer on carpeting where the pile height would prevent air from entering the dryer from the base.

●Check to see if the dryer is empty before loading it.

●The back of the dryer could become very hot. Never touch it while in use.

●Do not use the dryer unless the filter is securely in place (see Maintenance).

●Do not overload the dryer (see Laundry for maximum loads).

●Do not load items that are dripping wet.

●Carefully check all instructions on clothing labels (see Laundry).

●Do not tumble dry large, very bulky items.

●Do not tumble dry acrylic fibres at high temperatures.

●Do not turn off the dryer when there are still warm items inside.

●Clean the filter after each use (see

Maintenance).

●Do not allow lint to collect around the dryer.

●Never climb on top of the dryer. It could result in damage.

●Always follow electrical standards and requirements (see Installation).

●Always buy original spare parts and accessories (see Service).

4

Warnings

To minimise the risk of fire in your tumble dryer, the following should be observed:

●Tumble dry items only if they have been washed with detergent and water, rinsed and been through the spin cycle. It is a fire hazard to dry items that HAVE NOT been washed with water.

●Do not dry garments that have been treated with chemical products.

●Do not tumble dry items that have been spotted or soaked with vegetable or cooking oils, this constitutes a fire hazard. Oil-affected items can ignite spontaneously, especially when exposed to heat sources such as a tumble dryer. The items become warm, causing an oxidisation reaction with the oil, Oxidisation creates heat. If the heat cannot escape, items can become hot enough to catch fire. Piling, stacking or storing oil-effected items can prevent heat from escaping and so create a fire hazard. If it is unavoidable that fabrics containing vegetable or cooking oil or those that have been contaminated with hair care products be placed in a tumble dryer they should first be washed with extra detergent - this will reduce, but not eliminate the hazard. They should not be removed from the dryer and piled or stacked while hot.

●Do not tumble dry items that have previously been cleaned in or washed in, soaked in or soiled with petrol/gasoline, dry cleaning solvents or other flammable

or explosive substances. Highly flammable	GB
substances commonly used in domestic
environments including cooking oil,
acetone, denatured alcohol, kerosene,
spot removers, turpentine, waxes and
wax removers. Ensure these items have
been washed in hot water with an extra
amount of detergent before being dried
in the tumble dryer.

●Do not tumble dry items containing foam rubber (also known as latex foam), or similarly textured rubber like materials. Foam rubber materials can, when heated, produce fire by spontaneous combustion.

●Fabric softener or similar products should not be used in a tumble dryer to eliminate the effects of static electricity unless the practice is specifically recommended by the manufacturer of the fabric softener product.

●Do not tumble dry undergarments that contain metal reinforcements eg. bras with metal reinforcing wires. Damage to the tumble dryer can result if the metal reinforcements come loose during drying.

●Do not tumble dry rubber, plastic articles such as shower caps or babies water proof covers, polythene or paper.

●Do not tumble dry rubber backed articles, clothes fitted with foam rubber pads, pillows, galoshes and rubber coated tennis shoes.

●Remove all objects from pockets, such as lighters and matches.

! WARNING: Never stop the dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated.

5

Maintenance and Care

Switching off the electricity

GB

Unplug your dryer when not using it, when cleaning it and during all maintenance operations.

Clean the filter after each cycle

The filter is an important part of your dryer: it accumulates lint and fluff that is formed while drying.

Small items could also become trapped in the filter.

When finished drying, therefore, clean the filter by rinsing it under running water or with your vacuum cleaner. Should the filter become clogged up, the airflow inside the dryer will be seriously compromised: drying times lengthen and you will consume more energy. It may also damage your dryer.

The filter is found in front of the dryer trim (see diagram).

Removing the filter:

1. Pull the plastic grip of the filter upwards (see diagram).

2. Open the filter and clean the lint from the inside.

3.Replace it correctly. Ensure the filter is fully located flush into the tumble dryer trim.

4.Remove any lint that has built up on the inside of the door and around the door seal.

! Do not use the dryer without replacing the filter.

Check the drum after each cycle

Turn the drum manually in order to remove small items (handkerchiefs) that could have been left behind.

Cleaning the drum

! Do not use abrasives, steel wool or stainless steel cleaning agents to clean the drum.

A coloured film may start to appear on the stainless steel drum, this may be caused by a combination of water and, or cleaning agents such as fabric conditioner from the wash. This coloured film will not affect the dryer performance.

Cleaning

●External parts in metal or plastic and rubber parts can be cleaned with a damp cloth.

●Periodically check the vent tube and any permanent venting fixture to make sure that there has been no accumulation of fluff or lint, and remove it.

●Remove lint that collects around the filter and the outlet vents.

!Do not use solvents or abrasives.

!Have your dryer checked regularly by authorised technicians to ensure electrical and mechanical safety (see Service).

6