Hotpoint FFA60, FFA70, FFA80, FFS70 User Manual

FRIDGE FREEZER - MODELS FFA80, FFA70, FFS70 & FFA60

INSTRUCTIONS FOR INSTALLATION & USE

GETTING STARTED:

To ensure that your fridge freezer runs reliably and efficiently follow these steps.

STEP 1

Choose a location for your

fridge freezer,away from

any heat sources and

allow adequate

ventilation - 100mm

(4 inch) gap above.

STEP 3

Level the fridge freezer by

adjusting the front feet. This will stop rocking or

vibration and keep the

NB.The spanner is for illustration

only and is not supplied with the

door aligned.

fridge freezer.

STEP 5

Before plugging in and

switching on, leave the

fridge freezer in its final

location for at least 15

minutes to allow it to

settle.

STEP 2

STEP 4

STEP 6

Move the fridge freezer into position, using the sides of the cabinet. Take care to avoid damaging the refrigerant circuit pipe work on the rear.

After the front feet have been adjusted and the fridge freezer is level fit the left and right hand bottom hinge covers supplied. Align with the cover plate slots and push into position.

Plug in and switch on. Allow the fridge freezer to cool before placing food inside. The high temperature light will stay on until the fridge freezer has cooled down. All food in the fridge freezer should be covered.

INSTALLATION CONTROLS

SAFETY &

USEFUL ADVICE

MAINTENANCE

CLEANING &

TROUBLESHOOTING

STEP 7

If you are freezing fresh

food,turn on fast freeze

by pressing the switch 24

hours before placing the

Remember to turn fast freeze off

after 24 hours, however if you

forget to do so it will automatically

food inside.

Place the fresh food

inside.

cancel after 48 hours.

STEP 8

Your fridge freezer is now working. If after 24 hours your fridge freezer is not operating as you want, refer to the Troubleshooting section.

Read the rest of these instructions to get the best from your appliance

and remember to fill in your guarantee registration.

Keep this Book in a safe place for quick reference.

GUARANTEE

SERVICE &

For Your Safety

For your safety, read the following advice:

The fridge freezer cooling system contains a small amount of gas which is environmentally friendly but flammable. To avoid any risk :-

● Install the fridge freezer following the installation instructions and ensure that ventilation openings are kept clear of obstruction.

● Take care when installing or moving the fridge freezer to avoid damaging the pipes on the rear.

● If you suspect a leak, do not switch on the fridge freezer, but open the windows and doors to ventilate the room.

● Do not use any electrical devices inside the freezer,for instance for

SAFETY &

INSTALLATION

● Do not use any mechanical devices for defrosting other than any which may

● Only use this fridge freezer for storing domestic foodstuffs.

When installing your fridge freezer :-

● Ensure that the mains cable is not trapped underneath or behind the fridge

● Do not stack any other appliance on top of this fridge freezer as they may

defrosting.

have been supplied with the freezer as they may cause damage.

freezer when you install or move it.

damage the fridge or become unstable.

When using your fridge freezer :-

● Do not sit or stand on top of your fridge freezer.

● Do not store poisonous, flammable or dangerous substances in your fridge

freezer.

● Do not use aerosol sprays for defrosting or cleaning your fridge freezer.

If you sell the fridge freezer, pass on this booklet to the new owner.

Installation

Location & Air Circulation

Locate your fridge freezer away from sources of heat e.g.

100mm (4 inches)

cookers, radiators,direct sunlight as extreme temperature will affect its performance.

Allow a minimum 100mm (4 inches) between the top of the fridge freezer and the ceiling or the underside of a wall cupboard.

Providing you follow the recommended ventilation requirements you will :-

● Prolong the life of the fridge freezer.

● Minimise the risk of condensation on the outside of

the fridge freezer.

● Minimise the running costs.

● Minimise operating sounds caused by vibration.

Minimum space required to open door

The fridge freezer needs a space of 600mm (24 inches) in front to allow the door to open. When positioning the fridge freezer next to a unit, a gap of 30mm (1

/4inch) can be left at the hinge side of the door to allow the easy removal of furniture.If preferred the fridge freezer can be positioned so that a gap is not left.This will restrict how far the door can be opened but the furniture can still be removed (see diagrams below).The door hinge side can be changed to make it easier to open (see ‘Door Reversal’ in the CLEANING & MAINTENANCE section).

INSTALLATION

SAFETY &

600mm

TOP VIEW

30mm or more

TOP VIEW

600mm

less than 30mm

Installation

Levelling:

Level the fridge freezer when it is in its final location by adjusting the front feet, until firm contact is made with the floor. This will stop rocking or vibration and keep the door aligned which helps the fridge freezer run reliably and efficiently.

Note: Before plugging in and switching on,leave the fridge freezer standing in its final location for at least 15 minutes to allow it to settle.

Hinge Cover Mouldings:

After the front feet have been adjusted and the fridge freezer is level, fit the left and right hand bottom hinge covers supplied.

SAFETY &

INSTALLATION

To fit:

Align the bottom hinge cover onto the cover plate slots.

Push until the bottom hinge cover clicks into place.

Installation

Electrical Supply

WARNING:This appliance must be earthed.

The appliance must be positioned so that the plug is accessible after installation.

Fuses

Your appliance comes fitted with a plug and a 13A fuse. If you need to replace the fuse, only use those rated at 13A and ASTA approved to BS1362.

Changing the Plug

Cut off and dispose of the supplied plug if it does not fit your socket.

WARNING:To avoid a shock hazard do not insert the discarded plug into a socket anywhere else.

IMPORTANT WIRES IN THE MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE :

Green/Yellow - Earth

INSTALLATION

SAFETY &

Blue - Neutral Brown - Live

If you change the plug, the colour of wires in the mains lead may not correspond with the colour of the markings identifying terminals in the plug. You should therefore wire it as shown above.

Changing the Mains Lead

This appliance is fitted with a special mains lead. If you need to replace the mains lead due to damage, one can be bought from Hotpoint Service (see KEY CONTACTS, back page). It is strongly advised that this work is carried out by a qualified electrician.

CE Marking certifies that this appliance conforms to the following EEC directives : Low Voltage Equipment - 72/23/EEC & 93/68 EEC Electromagnetic Compatibility 89/336/EEC, 92/31/EEC & 93/68/EEC

Controls

Controlling the Temperature of the Fridge Compartment

The left hand control wheel on the front panel adjusts the internal fridge compartment temperature.

The internal temperature should be 5˚C or colder although some sections such as the salad bin will be slightly warmer. The setting of the control wheel will depend on the location of the fridge freezer, the room temperature and how often the door is opened. The normal set point (marked by a 3 on the dial) is usually suitable. If you need to adjust the temperature turn the control wheel using a coin to avoid damage:

Clockwise (higher number) - Colder Anti-clockwise (lower number) - Warmer

CONTROLS

Controlling the Temperature of the Freezer Compartment

The right hand control wheel on the front panel adjusts the internal freezer compartment temperature.

FFA70 illustrated

The internal temperature should be -18˚C or colder. The setting of the control wheel will depend on the location of the fridge freezer, the room temperature and how often the door is opened. The normal set point (marked by a 3 on the dial) is usually suitable. If you need to adjust the temperature turn the control wheel using a coin to avoid damage:

Clockwise (higher number) - Colder Anti-clockwise (lower number) - Warmer

You can check the temperature of the fridge freezer compartments by using a Fridge Freezer Thermometer available from Hotpoint Genuine Parts and Accessories Mail Order Hotline (see KEY CONTACTS back page).

WARNING: Do not use a mercury filled thermometer,as breakage would cause a health hazard.

Your fridge freezer must NOT be placed in a room where the temperature goes below 6˚C or above 38˚C for prolonged periods,as the internal fridge temperature will not be maintained.

Controls

FFA70 illustrated

Indicator Lights

There are two amber lights which indicate functions are selected:

● The amber fast freeze light indicates that the fast freeze button has been

pressed on. By pressing this button ON,the freezer motor will run continuously for extra cooling.

● The amber holiday light (Models FFA80,FFA70 & FFS70 only) indicates that the

holiday mode is set.

There are two red lights which warn of a rise in temperature in the freezer compartment:

● The red high temperature warning light will come on when the fridge freezer is

first switched on or when the temperature inside the compartment rises above the correct storage temperature. It will go out as soon as the compartment returns to its normal storage temperature.

The red light may come on for a short period when opening the freezer door to load or unload food,in this case storage times will not be affected. If there has been a power cut resulting in a rise in freezer compartment temperature,the red high temperature warning light will come on as soon as the mains power returns. It will go out as soon as the compartment returns to its normal storage temperature.

Avoid opening compartment doors during a power cut,the freezer insulation will continue to protect your food. However if the power cut continues, there is a risk of your frozen food beginning to defrost due to the rise in temperature.

● The red food defrost alert light (Models FFA80,FFA70 & FFS70 only) will also

come on when the mains power is restored to warn there has been a power cut and the freezer compartment temperature has risen to an unsafe level allowing partial defrosting of stored food. If this light is ON, food should be either cooked and eaten within 24 hours, cooked and refrozen or thrown away. The red food defrost alert light is a particularly useful warning light if you were out at the time of the power cut. The light will remain on until cancelled. It can only be cancelled by pressing the button alongside it.

CONTROLS

Check the TROUBLESHOOTING section if you have any problems with these indicator lights.

Controls

Fast Freeze Button - Freezing Fresh Food

The bottom compartment drawer should be used to freeze fresh food. Transfer already frozen food to one of the upper drawers.

- Before loading 2kg or more of fresh food select fast freeze for the required

pre-freeze time (see chart below).

- If freezing up to 2kg of fresh food just select fast freeze when loading.

Once the fresh food is loaded leave fast freeze on for 24 hours to freeze the food as quickly as possible.

Maximum freezing capacity 24 hours: FFA70/FFS70 12kg

FFA80/FFA60 8kg

Note : Don’t forget to turn fast freeze off after 24 hours from the introduction of fresh food to be frozen. However fast freeze will turn off automatically after 48 hours if you do forget.

CONTROLS

Model

FFA70 FFS70

FFA60 FFA80

FFA70 FFS70

FFA60 FFA80

FFA70 FFS70

FFA70 FFS70 FFA60 FFA80

Pre-Freeze chart when selecting Fast Freeze:

Load for freezing Pre-freeze time Load position

8 to 12kg max. 24 hours In the bottom drawer.

6 to 8kg max. 24 hours

6 to 8kg 12 hours In the bottom drawer.

2 to 6kg 12 hours

In the bottom drawer.

2 to 6kg 6 hours

up to 2kg not required In the bottom drawer.

Controls

Holiday Function (Models FFA80, FFA70/FFS70 only)

This feature allows you to set your fridge compartment to a warmer setting while you are away on holiday, to reduce running costs without affecting the freezer.

To set up holiday mode:

1. Remove any food,from the fridge compartment, that will deteriorate while you are away. Make sure the fridge is clean.

2. Close the door.

3. Press the holiday button and the amber holiday indicator light will show that holiday mode is set.

To reset to normal operation:

1. Press the holiday button OR open the fridge door. The amber holiday indicator light will go out to show holiday mode is cancelled.

2. The fridge compartment will return to the temperature set on the fridge temperature control wheel.

Note : Opening the door or pressing the holiday button at any time after holiday mode has been set will turn the function off. The holiday button works independently of the fridge temperature control wheel.

CONTROLS

+ 19 hidden pages