Hotchkis 22407R User Manual

22406, 22407, 22407R SWAY BAR SET

2002-UP SUBARU WRX

Thank you for your purchase from our line of Subaru WRX parts.

Please call us at (877) 4NO-ROLL if you have any questions regarding the service or installation

of your Hotchkis products. Visit us on the web @

www.hotchkis.net

• This installation will require:

 Hydraulic jack, ramps, torque wrench
 The following wrenches or sockets: 12mm, 14mm, 17mm

 Allen wrenches or hex sockets: 6mm

INSTALLATION OF HOTCHKIS FRONT SWAY BAR

1) Securely block the rear wheels of the vehicle. Use a jack to raise the front end of the vehicle
and support it on ramps. You MUST install the front bar with the car on the wheels. Observe
the stock front sway bar installation for reference.

2) Remove the plastic splashguard from under the front of the vehicle. It is held in place by small

plastic clips that can be removed by hand. Retain the clips and splashguard for re-installation.