Hotchkis 22400 User Manual

22400 STREET SWAY BAR SET

00-UP TOYOTA CELICA

Thank you for your purchase from our line of Toyota Celica parts.

Please call us at (877) 4NO-ROLL if you have any questions regarding the service or

installation of your Hotchkis products. Visit us online @ www.hotchkis.net

 Hotchkis recommends that this sway bar set be installed by a professional, as the front

sway bar can only be removed or installed by detaching the front engine cradle and

lowering it from the vehicle!

Tools required for this installation:

 Hydraulic jack, jack stands, torque wrench
 The following sockets or wr ench es: 12m m, 1 4m m, 17 mm , 19m m

 The following Allen wrenches: 6mm

 Suggested tools: 6” socket extension, swivel ratchet

INSTALLATION OF HOTCHKIS FRONT SWAY BAR

1) Securely block the rear wheels of the vehicle. Use a jack to lift up the front of the vehicle and
use jack stands to support it. Do not remove the front wheels during installation for safety.

2) Use a 14mm wrench and 6mm Allen wrench to remove the nuts holding the end links to the
ends of the stock sway bar. Remove the end links from the ends of the sway bar. Retain the
hard ware for later use.