Hotchkis 16366 User Manual
P
16366 66-70 B-Body, 70-74 E-Body
16366
Steering Tie Rods
1966-1970 Chrysler B-Body, Charger,
Super Bee, Road Runn er, GTX
1970-1974 Chrysler E-Bod y, Cuda, Challenger
Thank you for your purchase from our new line of B & E-Body parts.
Please call us at (877) 4NO - ROLL if you have any questions
regarding the service or installation of your Hotchkis products.
Hotchkis Performance LLC . 1
16366 66-70 B-Body, 70-74 E-Body
Before You Start :
Please read the entire manual before starting. These steering tie rods were
designed to reduce weight, provide rigid steering feel, and allow for shimming
for reducing bump steer. We highly recommend using our (P/N:1110) Upper AArms in conjunction with your Hotchkis steering tie rods for maximum sus pension
geometry and performance.
1. Raise Vehicle
Raise the vehicle and put it up on jack stands. You may al so use a 2-post or 4post lif t.
2. Remove Stock Steering Tie Rods
Remove the left and right stock steering tie rods from the vehicle. A big hammer
is your friend in removing the ball joint studs from center link and spindle. A
pickle fork may be needed if they are really tight.
3. Set Initial lengths for the Hotchkis Tie Rods
With the stock tie rods off, measure the center to center dimension of each link.
Spin the hotchkis turnbuckle so that the center to center dimension matches the
stock part. This will be an initial setting. A front end toe alignment will be
needed once the tie rods are in place.
Hotchkis Performance LLC . 2
Loading...