Hoshizaki America Reach-In Installation Manual

Hoshizaki Professional Series

REACH-IN MODEL

MAIN POWER
SWITCH

TEMPERATURE
CONTROLLER

2 HOSHIZAKI HEATED HOLDING CABINET

Heated Holding Cabinet

INSTALLATION

CONGRATULATIONS...

...and thank you for purchasing a Hoshizaki Heated Holding Cabinet.
Your unit has been designed and manufactured under rigid controls
to assure you the most efficient service. It is a full time unit,
and may be used continuously.

Please take a moment to read through this booklet of important
information pertaining to your cabinet. By following a routine of
proper use and care described on the following pages, your cabinet
will last for many years.

IMPORTANT: Your Manufacturer Registration Card must be
returned within 30 days after initial delivery to activate the warranty.

SERIAL AND MODEL NUMBER

Facing the rear of the unit, the serial tag is located at the top
right. For Pass-Thru Models, facing the control side, the serial
tag is located top rear of the left side. Please record the serial
and model number in this booklet in the space provided on
page 10. When ordering parts and/or service, you will need to
provide this information. The voltage and amperage of the unit
are also stamped on the serial tag.

UNPACKING

Keep unit properly balanced. Weight of the components
are at the top. Do not allow unit to tip over. After uncrating
your cabinet, remove all tape and padding which held all
doors, shelves, racks, cord, etc., in place during shipment.

PROFESSIONAL SERIES

3

Hoshizaki Professional Series

WARNINGS

ELECTRICAL REQUIREMENTS
AND GROUNDING

Hoshizaki standard models operate on 110/120 volt, 60 Hz, 1 ph,
A.C. (unless ordered otherwise), and are equipped with a three
prong grounding cord plug for your protection against possible
shock hazards. Be sure to plug only into a properly grounded
three prong wall receptacle. If you have any questions with
regard to adequate wiring or grounding in your building, a
qualified electrician should be contacted before using your
cabinet. The amperage of your cabinet is stamped on the
name plate attached to the unit.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.

WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD

ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.

BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.

4 HOSHIZAKI HEATED HOLDING CABINET