IMPORTANT
Only qualified service technicians should attempt to install, service or maintain this
icemaker. No installation, service or maintenance should be undertaken until the
technician has thoroughly read this Instruction Manual. Likewise, the
owner/manager should not proceed to operate the icemaker until the installer has
instructed them on its proper operation.
HOSHIZAKI provides this manual primarily to assist qualified service technicians in the
installation, maintenance and service of the icemaker.
Should the reader have any questions or concerns which have not been satisfactorily
addressed, please call or write to the HOSHIZAKI Technical Support Department for
assistance.
HOSHIZAKI AMERICA, INC.
618 Highway 74 South
Peachtree City, GA 30269
Attn: HOSHIZAKI Technical Support Department
Phone: 1-800-233-1940 Technical Service
(770) 487-2331
Fax: (770) 487-3360
NOTE: To expedite assistance, all correspondence/communication MUST include the following
information:
• Model Number
• Serial Number
• Complete and detailed explanation of the problem
2
• Please review this manual. It should be read carefully before the icemaker is installed
and operated. Only qualified service technicians should install, service and maintain the
icemaker. This manual should be made available to the technician prior to installation,
maintenance or service.
• Keep this manual with the icemaker for later reference.
CONTENTS PAGE
I. SPECIFICATIONS...................................................................................................4
1. NAMEPLATE RATING..........................................................................................4
[a] KM-1600SWH (Water-cooled) .........................................................................4
[b] KM-1600SRH (Remote Air-cooled)..................................................................5
[c] KM-1600SWH3 (Water-cooled)........................................................................6
[d] KM-1600SRH3 (Remote Air-cooled)................................................................7
2. DIMENSIONS/CONNECTIONS ............................................................................8
[a] KM-1600SWH, KM-1600SWH3 .......................................................................8
[b] KM-1600SRH, KM-1600SRH3 ........................................................................9
II. INSTALLATION AND OPERATING INSTRUCTIONS..........................................10
1. CHECKS BEFORE INSTALLATION...................................................................10
2. HOW TO REMOVE PANELS..............................................................................10
3. LOCATION..........................................................................................................11
4. SET UP...............................................................................................................11
5. INSTALLATION OF THE SECOND UNIT ...........................................................14
6. ELECTRICAL CONNECTION .............................................................................15
7. INSTALLATION OF REMOTE CONDENSER UNIT............................................16
[a] CHECKS BEFORE INSTALLATION..............................................................16
[b] LOCATION.....................................................................................................16
[c] SET UP ..........................................................................................................17
[d] ELECTRICAL CONNECTION ........................................................................18
[e] STACKING CONDENSER UNIT....................................................................19
8. WATER SUPPLY AND DRAIN CONNECTIONS ................................................20
9. FINAL CHECK LIST............................................................................................22
10. START UP..........................................................................................................23
11. PREPARING THE ICEMAKER FOR LONG STORAGE ....................................24
III. CLEANING AND MAINTENANCE INSTRUCTIONS ...........................................26
1. CLEANING INSTRUCTIONS ..............................................................................26
[a] CLEANING PROCEDURE.............................................................................26
[b] SANITIZING PROCEDURE...........................................................................28
2. MAINTENANCE ..................................................................................................29
3
I. SPECIFICATIONS
1. NAMEPLATE RATING
[a] KM-1600SWH (Water-cooled)
See the Nameplate for electrical and refrigeration specifications. This Nameplate is located on the upper right hand
side of the rear panel.
Since this Nameplate is located on the rear panel of the
icemaker, it cannot be read when the back of the icemaker
is against a wall or against another piece of kitchen equipment. Therefore, the necessary electrical and refrigeration
information is also on the rating label, which can be easily
seen by removing only the front panel of the icemaker.
We reserve the right to make changes in specifications and design without prior notice.
4
[b] KM-1600SRH (Remote Air-cooled)
See the Nameplate for electrical and refrigeration specifications. This Nameplate is located on the upper right hand
side of the rear panel.
Since this Nameplate is located on the rear panel of the
icemaker, it cannot be read when the back of the icemaker
is against a wall or against another piece of kitchen equipment. Therefore, the necessary electrical and refrigeration
information is also on the rating label, which can be easily
seen by removing only the front panel of the icemaker.
We reserve the right to make changes in specifications and design without prior notice.
5
[c] KM-1600SWH3 (Water-cooled)
See the Nameplate for electrical and refrigeration specifications. This Nameplate is located on the upper right hand
side of the rear panel.
Since this Nameplate is located on the rear panel of the
icemaker, it cannot be read when the back of the icemaker
is against a wall or against another piece of kitchen equipment. Therefore, the necessary electrical and refrigeration
information is also on the rating label, which can be easily
seen by removing only the front panel of the icemaker.
We reserve the right to make changes in specifications and design without prior notice.
6
[d] KM-1600SRH3 (Remote Air-cooled)
See the Nameplate for electrical and refrigeration specifications. This Nameplate is located on the upper right hand
side of the rear panel.
Since this Nameplate is located on the rear panel of the
icemaker, it cannot be read when the back of the icemaker
is against a wall or against another piece of kitchen equipment. Therefore, the necessary electrical and refrigeration
information is also on the rating label, which can be easily
seen by removing only the front panel of the icemaker.
We reserve the right to make changes in specifications and design without prior notice.
7
2. DIMENSIONS/CONNECTIONS
[a] KM-1600SWH, KM-1600SWH3
units: inches (mm.)
Note: When used with a storage bin not recommended by Hoshizaki, the icemaker needs
the space at the bottom opening as in the illustration.
8
[b] KM-1600SRH, KM-1600SRH3
units: inches (mm.)
Note: When used with a storage bin not recommended by Hoshizaki, the icemaker needs
the space at the bottom opening as in the illustration.
9