Horton M910 Owner's Manual
A Member of
Contents
AAADM
American Association of Automatic Door Manufacturers
AUTOMATIC SECURITY
REVOLVING DOOR
OWNER'S MANUAL
Distributed by:
Section Page
Caution 2
To Our Customers 2
Service Availability 2
What You Should Know 2
Daily Safety Check 2 & 3
General Safety 4
Limited Warranty 4
2
! CAUTION
• Failure to follow instructions can result in an improperly adjusted door and can,
consequently, cause injury and damage to equipment and property.
• Should the door fail to operate as prescribed in the “Daily Safety Check” of this
Owner’s Manual or if a potentially hazardous situation is suspected, the door should
be taken out of automatic service until a professional inspection is made and the
problem is corrected.
DO NOT ATTEMPT TO REPAIR OR ADJUST THE DOOR YOURSELF.
To Our Customers
It is essential that you know your door system and that you recognize the importance of maintaining the
system in compliance with all applicable local and national building codes. Your local Horton Automatics
service representative will be familiar these codes and Horton Automatics recommendations for security
revolving doors. Maintenance and adjustments performed by this service representative/technician will ensure
safe and proper.
Service Availability
Horton Automatics’ products are manufactured at the plant’s facilities in Corpus Christi, Texas and Telford,
England. A worldwide network of authorized independent distributors offers both installation and service. For
the Horton Automatics distributor in your area call 1-800-531-3111 or consult the Yellow Pages of your local
telephone directory under “Door-Operating Devices.” In Europe, call the plant in Telford, England at 011-441952-670169.
What You Should Know
Your local Horton Automatics distributor should provide you with the following for each door after installation:
• Instructions on the safe operation of the door
• Location of power cut-off switch.
• Necessary warnings not covered in these instructions
• Walk-through example of conducting “Daily Safety Check”
• This M910 Owners Manual with the following items filled in:
_____________Phone number to call regarding problems or request for service
_____________Date equipment shipped from Horton plant
_____________Date equipment placed in service
_____________Horton Automatics’ invoice number for Warranty reference and repairs
_____________Equipment type (door series) & Activation/Accessories ________________________
_________________________________________________________________________________
_____________Control logic version number
Daily Safety Check - It is the responsibility of the owner or caretaker of the equipment to perform the
following safety checks each day and after any loss of electrical power:
A. Activation by Card Readers - To activate revolving door, present access card to card reader located on
one or both sides of door. A Horton Automatics supplied LED located on the card reader mounting bracket will
change from red to green indicating valid presentation. An audible one-second beep should also be heard
simultaneous to the LED color change. Note: If the card reader response is greater than 2 seconds, traffic
through the revolving door will be slowed. Ask card reader's manufacturer for instructions to decrease
response time. A revolving door with wings in standard 'plus' (+) position will allow valid user 8 seconds or 3
attempts to enter door. With wings in (x) position, valid user wilt be given three quadrant rotations to
successfully enter door.
Loading...