Horton C1160-5 Installation Manual

®

4242 Baldwin Boulevard
Corpus Christi, Texas
USA 78405-3399
Tel: [phone]
Fax: [phone]

www.hortondoors.com

A U T O M A T I C S

The Automatic Choice

Standard Packages

GENERAL INSTALLATION & OPERATION

DRIVE-THRU SERVICE WINDOWS

TypIcal Mounting of HipScan Sensor

TM

D1.2

Jan 08

C1160-5 Product description:

A surface applied activating device that includes
a stainless steel base and two molded Lexan enclosures. One enclosure
contains a photoelectric transmitter; the other matching enclosure contains a
photoelectric receiver. The system responds to an interruption ofthe light path
between the Lexan enclosures; this interruption signals the window to open.

Wiring to C7782 amplifer

Splice into the switch
(see page 16 wiring diagram)

1/4" hole for wire
routing

18ga Stainless
steel base

Receiver Pod

#6 x 3/8" FHSMS
Hold the cover on

#10 x 1 1/2" PHSMS
Mounting screws

Transmitter Pod

The C1160-5 assembly should be mounted inside and
directly in front of the window so when the user leans
against the counter, he is also between
the Lexan enclosures. Note: The electrical contractor
should provide accessible route from the mounting
location to the base of the window lock jamb, routing the
24 VAC, Class II control wire to the operator.