Horsepower Technologies FastTrack Heating And Fitting Manual
FastTrack
™
Heating and Fitting Guide
Congratulations on your purchase of
Horsepower Technologies FastTrack™. Please
take a moment to read these instructions
before using the Heater Kit and FastTrack™.
You can find step-by-step videos online at
http://www.horsepowertech.com/support
For questions or comments please contact:
Customer Support
844-51-HORSE
support@horsepowertech.com
or visit www.horsepowertech.com
WARNING:
1. Correct and accurate fit is critical to this device's proper
performance.
• Carefully read instructions and warnings prior to use.
2. Use extreme caution while using the Heater Kit as this
device and FastTrack™ become very hot during use.
3. To avoid potential fire hazards always ensure the Heater
Kit is placed on clean, dry and level surfaces prior to use.
4. If unit is damaged or inoperable, please discontinue use
and call Customer Support: 844-51-HORSE.
5. A fire may result if the Heater Kit is not used with care,
therefore:
• Be careful when using the Heater Kit in places where
there are combustible materials.
• Do not use in presence of an explosive atmosphere.
• Be aware that heat may be conducted to combustible
materials that are out of sight.
• Allow Heater kit to cool down before storage.
• Do not leave the Heater Kit unattended when it is
switched on.
6. If the supply cord is damaged it must be replaced by the
manufacturer, its service agent, or similarly qualified
persons in order to avoid a hazard.
7. For your safety, please use included heat-resistant
gloves.
8. Horses are prone to sudden movements, please exercise
caution while applying and fitting FastTrack™.
9. Unplug the Heater Kit when not in use.
1 2
4. Remove bag with heat-resistant gloves.
5. Check to make sure the power switch is
in the “Off” position.
1. Ensure Heater Kit is placed on a clean,
dry and level surface.
WARNING: Remove hay or potentially
combustible materials surrounding
heater as this could be a fire hazard.
Do NOT leave Heater Kit unattended
during use.
2. Undo both side latches.
3. Remove cover and set aside.
Set Up Heater Kit
1
Heater Kit Features
43
Loading...