Horng Technical Enterprise HTM69WRT User Manual

Wireless optical Mouse

HTM-69WRT

User’s Manual

Features

p

u

f

 Designed using a FSK transmitter.

 Two kinds of USB receivers-Dongle and Shark.

 Idealized for desktop PC and notebook with smart storage function

 4 modes of operations to lower the power consumption.

 Single channel at frequency 27 MHz with 256 IDs to prevent signal

interference.

 Longer transmission distance (Min. 1.5M)

R

 Used for USB interface with operation system Windows

○

.

 800 DPI optical sensor used on most surfaces.

 LED indicator in receiver for mouse linkage.

Product Specification

Item Description

Product RF Wireless Optical Mouse

Mouse Model Type No. HTM-69WRTU

Dongle Model Type No. RS9

Movement Sensor Optical Sensor

Resolution 800dpi

Operating Frequency 27MHz

Distance Min 1.5M

Power Supply 2*AAA Batteries

Installation of the mouse

1. Pull out the USB receiver from the bottom of the mouse; plug the receiver into

the USB port. Switch the computer on running Win98, Win2000, XP ,NT &

ME. The mouse should be automatically recognized by the system.

2. When insert the batteries into battery compartment, ensure correct polarity as

indicated ("+" and "-") and optical sensor should be switched on after that.

3. Set up digital ID

● Aim the front of the mouse to the receiver.

● Press ID switch at the bottom of the mouse and the one on the receiver. The

mouse and receiver will be co-ordinated and ready to operate.

● When setup, the LED on the receiver flashes for 1-2 sec. Once ID setu

completed, the LED will stop flashing.

(Ps. If setup procedure is failed, repeat the process until succeeding.)

4. Now whenever you move the mouse or click any one of the buttons, the data

receipt confirmation LED will switch on. If you stop working the mouse, the

LED will turn to flash after 16 sec., then the LED will be switched off after 16

mins. (Auto power saving function) If you want to wake up the mouse, all yo

need to do is just to click any button. This is our power saving design.

5 The digital ID in the mouse will not be changed by rebooting, switching of

computer or exchanging mouse to the other computer. But, once replace the

batteries, it will be essential to sep up new digital ID again.(refer to point. 3)

Left button Right button ID switch

ID switch

is

Power Saving Operation 4 modes

Consuming Current 26mA @ 3V at full speed

Security ID Code 256 Sets

System Requirements

IBM or compatible PC

Windows 98/ME /2000//XP

Interface USB1.1

Click/scroll wheel

Battery cover

Receiver LED

9