Hornady Sonic Cleaner User Manual

Lock-N-Load®

Sonic Cleaner

Instruction Manual

™

2L

Thank you for purchasing the Hornady Lock-N-Load® Sonic Cleaner.™
Please read these instructions before using this machine. If you have
any questions about this accessory, contact us at 1-800-338-3220.

The Hornady Lock-N-Load® Sonic Cleaner™ removes carbon residue from
the inside and outside of cartridge cases with high frequency ultrasonic
energy and a specialized cleaning solution. Unlike case tumblers, the
Lock-N-Load® Sonic Cleaner™ effectively cleans the inner surfaces
of cartridge cases as well as the primer pockets. The Lock-N-Load®
Sonic Cleaner™ features a 2 liter stainless steel tank, removable basket,
heating function, and a digital timer. The Lock-N-Load® Sonic Cleaner™
may also be used to clean other small parts.

The primary function of the Lock-N-Load® Sonic Cleaner™ is to
chemically and mechanically clean a variety of items. It may or may
not produce “shiny” brass. To create bright and polished brass we
recommend using the Hornady Case Tumbler. Not all carbon buildup
and tarnish may be removed from cases due to the corrosive nature of
some primer residue and/or deep corrosion.

DE-GAS FUNCTION

The Hornady Lock-N-Load® Sonic Cleaner™ includes a de-gassing
function to remove excess air bubbles from the solution, improving
the effectiveness of the ultrasonic cleaning action. The de-gassing
function cycles the unit on and off, causing air bubbles to release from
the solution and float to the surface. To turn on the de-gas function,
press the FUNCTION button repeatedly until the symbol above the
De-gas label is illuminated. Then turn the unit on by pressing the ON/
OFF button. After de-gassing for 90 seconds, the unit will return to
regular ultrasonic cleaning until the timer expires.

HEATING FUNCTION

The Hornady Lock-N-Load® Sonic Cleaner™ includes a heating
function to further enhance the ultrasonic cleaning action. The
heating function may be used on must gun components, however
caution should be used with any heat sensitive items.

Most brass cartridges do not need heat to ef ficiently clean. Using the
heating function during prolonged cleaning cycles may actually cause
tarnishing to appear.

To turn on the Heating function, press the HEAT button until the heater
light turns on. The unit will then heat to approximately 135°F when the
ultrasonic cleaner is turned on. The heater light will continue to flash
until the solution reaches the target temperature of 135°F, at which
time the light will turn off.