Hornady Lock-N-Load Bench Rest Powder Measure User Manual

Bench Rest Grade

Setup and Instructions

Your “Bench Rest Grade LNL Powder Measure” has been nickel plated for
long life and corrosion control, however it has also been treated with a rust
preventative, which must be removed before use.

We recommend that you clean and degrease all moving parts with Hornady One
ShotGun Cleaner and Dry Lube. (Black Label)

To Disassemble:

1. Set the rotor; with the Metering Device horizontal, press the Push Button and
hold it down while removing the Metering Device.

2. Remove the Handle, from the Powder Measure, by removing the two attaching
screws with a 1/8” hex wrench.

3. Slide the Rotor out of the Housing by pressing gently on the handle side of the
Rotor.

4.Be careful not to drop or otherwise damage the Rotor while it is out of the Body.

5. Turn the Micrometer thimble in the full forward position “0” to extend the
rod and head from the Sleeve. (It should not be necessary to disassemble the
Micrometer unit.) Spray all metal parts liberally with Hornady One Shot-Gun
Cleaner and Dry Lube. Be sure all rust preventative is removed.

6. Allow it to dry thoroughly before reassembling it.

To Assemble:

Reverse the procedure in steps 1-4.

The Rotor and Housing are very closely fit and must be properly
aligned to reassemble.

DO NOT FORCE IT, OR IRREPAIRABLE DAMAGE WILL OCCUR.