Hornady 98141 User Manual
Table of Contents
Warnings and Important Information ................................................. Page 2
Items Included........................................................................................ Page 3
Setup and Operation ............................................................................. Page 4
Warranty .................................................................................................. Page 9
Product Registration and Service ...................................................... Page 10
Frequently Asked Questions ............................................................... Page 10
Mounting Template ............................................................................... Page 11
Items included with your RAPiD® Safe
1. RAPiD® Safe 2600KP or RAPiD® Safe 2700KP
2. Wall Power Supply
3. One (1) RFID Adjustable Wristband (No. 98141)
4. Two (2) RFID Adhesive Decals (No. 98168)
5. One (1) RFID Key Fob Tag (No. 98167)
6. Two (2) Circular Barrel Keys
7. Security Cable
Not Pictured:
• Owner’s Manual
• Warranty Card
1
2
6
4
5
7
RAPiD Safe 2600KP
Item No. 98177
Exterior: 10.7"x 8.7" x 2.9"
Interior: 7.0" x 7.7" x 2.2"
Power : 12 V 1.0A or four (4) A A bat teries
(batteries not included)
16-HMC-0113 Instructions Rapid Safes 2600KP-2700KP - INSIDE PGS-4A.indd 3 8/25/16 4:14 PM
RAPiD Safe 2700KP
Item No. 98172
Exterior: 12.7" x 8.7" x 2.9"
Interior: 9.0 " x 7.7" x 2.2"
Power: 12 V 1.0A or four (4) AA batteries
(batteries not included)
3
3
RAPiD® Safe Setup and Operation
Congratulations on purchasing the technologically advanced RAPiD® Safe.
You have taken a significant step in securing the safety of your handgun.
To achieve the best experience with your RAPiD® Safe, please read all
instructions carefully, and understand its operation.
After the RAPiD® Safe has been taken out of the box, please check to be sure
both circular barrel keys fit and unlock your RAPiD® Safe. Contact Hornady®
at 800-338-3220 if the keys do not work. Store keys in a secure location
outside the safe.
AC Power
The RAPiD® Safe is designed to be
powered by either the AC power
supply or four AA batteries.
To connect the AC power supply,
first open the safe with the circular
key, and then press in the lid’s stop
catches to fully extend the lid for
easy access. Remove the foam from
the lower compartment, and insert
the power jack through the square
hole in the bottom of the safe. With
the battery door closed, plug the
AC power supply into the back of
the front panel. The cord should be
routed to the left side of the safe
before reinserting the foam.
Batteries
For backup or mobile use, your safe
requires four AA batteries (not included).
To install batteries, remove inner foam
from base and verify AC adapter is
uplugged. Press down on the two lock
tabs and rotate door forward on the
battery compartment. Only use new
high quality AA batteries. Replace all
batteries at the same time.
Stop Catches
Foam
Power Jack
Power Jack
4
16-HMC-0113 Instructions Rapid Safes 2600KP-2700KP - INSIDE PGS-4A.indd 4 8/25/16 4:14 PM
To check battery level:
1. Disconnect from AC power source.
2. Press and release “H” button
on the lid.
3. The LED light on the “H” button
will flash.
a. Flashing Green – Good battery
b. Flashing Yellow – Low battery
c. Flashing Red – Dead battery
4. After 10 seconds the safe will
return to normal operation.
NOTE: Replace batteries every twelve
months or if they become weak.
Battery Power Mode
When the RAPiD® Safe is unplugged,
and is operating on battery power, you
must press any button on the lid to
activate the reader.
Pressing any button on the lid causes
the system to go from battery saving
mode to ready status.
“H” But ton
Lock Tabs
RFID Reader
& Key Pad
For example: To open your safe with an
RFID tag, while the system is running on
battery power, first press any button on
the lid to bring it to ready status. Place
your RFID tag within 1" of the center of
the RFID reader to open the safe.
Keypad Tones On/Off
Press and hold the “H” button on the
keypad for 5 seconds until the light turns
off to toggle sound on and off.
5
16-HMC-0113 Instructions Rapid Safes 2600KP-2700KP - INSIDE PGS-4A.indd 5 8/25/16 4:14 PM
Loading...