Right motor
A
EN
Propeller Service
CAUTION: DO NOT handle propeller parts
while the fl ight battery is connected. Personal
Left motor
BC
injury could result
1. Remove the spinner (A) by carefully pulling it
away from the propeller (B). Remove residue
from the spinner and propeller if applicable.
2. Remove the propeller from the motor shaft,
noting the “L” or “R” indicator. Use a pair of
needle nose pliers or hemostats to hold the
motor shaft (C) in place, then carefully pull
the propeller from the motor shaft.
3. Install a new propeller with the size numbers
facing out from the motor.
• 4.75 x 2.5 R (Right)
• 4.75 x 2.5 L (Left)
4. Reinstall the spinner using foam
safe CA (Cyanoacrylate adhesive).
A list of available replacement parts is in
the back of the manual. Visit the web site
www.????????????.com for more information
about maintaining your aircraft.
24 in
(60 cm)
Binding
If your aircraft does not respond to the
transmitter when the batteries in the aircraft and
transmitter are fully charged, bind your aircraft
and transmitter by using the instructions below.
1. Disconnect the fl ight battery from the aircraft.
2. Power off the transmitter.
3. Connect the fl ight battery to the aircraft. The
3.
5
Sec.
5.
6.
11
receiver LED will begin to fl ash (typically after
5 seconds)
4. Hold the transmitter more than 24 inches
(60 cm) away from the aircraft. Keep away
from large metal objects, wireless sources
and other transmitters. Make sure your
transmitter’s controls are neutral, the throttle
is in the low position, and the aircraft is
immobile.
5. Push the right control stick into the case until
it clicks, as you power on the transmitter.
6. The transmitter will beep twice and the LED
will fl ash. Release the stick after 2 seconds.
7. After 5 to 10 seconds, the receiver status LED
will begin fl ashing slowly and the transmitter
will stop beeping, indicating the receiver is
bound to the transmitter.
RTF
EN
Limited Warranty
What this Warranty Covers
Horizon Hobby, Inc., (Horizon) warrants to the
original purchaser that the product purchased (the
“Product”) will be free from defects in materials and
workmanship at the date of purchase.
What is Not Covered
This warranty is not transferable and does not cover
(i) cosmetic damage, (ii) damage due to acts of God,
accident, misuse, abuse, negligence, commercial
use, or due to improper use, installation, operation
or maintenance, (iii) modifi cation of or to any part of
the Product, (iv) attempted service by anyone other
than a Horizon Hobby authorized service center, (v)
Product not purchased from an authorized Horizon
dealer, or (vi) Product not compliant with applicable
technical regulations.
OTHER THAN THE EXPRESS WARRANTY ABOVE,
HORIZON MAKES NO OTHER WARRANTY OR
REPRESENTATION, AND HEREBY DISCLAIMS ANY
AND ALL IMPLIED WARRANTIES, INCLUDING,
WITHOUT LIMITATION, THE IMPLIED WARRANTIES
OF NON-INFRINGEMENT, MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE. THE
PURCHASER ACKNOWLEDGES THAT THEY ALONE
HAVE DETERMINED THAT THE PRODUCT WILL
SUITABLY MEET THE REQUIREMENTS OF THE
PURCHASER’S INTENDED USE.
Purchaser’s Remedy
Horizon’s sole obligation and purchaser’s sole and
exclusive remedy shall be that Horizon will, at its
option, either (i) service, or (ii) replace, any Product
determined by Horizon to be defective. Horizon
reserves the right to inspect any and all Product(s)
involved in a warranty claim. Service or replacement
decisions are at the sole discretion of Horizon. Proof
of purchase is required for all warranty claims.
SERVICE OR REPLACEMENT AS PROVIDED UNDER
THIS WARRANTY IS THE PURCHASER’S SOLE AND
EXCLUSIVE REMEDY.
Limitation of Liability
HORIZON SHALL NOT BE LIABLE FOR SPECIAL,
INDIRECT, INCIDENTAL OR CONSEQUENTIAL
DAMAGES, LOSS OF PROFITS OR PRODUCTION OR
COMMERCIAL LOSS IN ANY WAY, REGARDLESS OF
WHETHER SUCH CLAIM IS BASED IN CONTRACT,
WARRANTY, TORT, NEGLIGENCE, STRICT LIABILITY
OR ANY OTHER THEORY OF LIABILITY, EVEN IF
HORIZON HAS BEEN ADVISED OF THE POSSIBILITY
OF SUCH DAMAGES. Further, in no event shall the
liability of Horizon exceed the individual price of the
Product on which liability is asserted. As Horizon
has no control over use, setup, fi nal assembly,
modifi cation or misuse, no liability shall be assumed
nor accepted for any resulting damage or injury. By
the act of use, setup or assembly, the user accepts
®
all resulting liability. If you as the purchaser or user
are not prepared to accept the liability associated
with the use of the Product, purchaser is advised to
return the Product immediately in new and unused
condition to the place of purchase.
Law
These terms are governed by Illinois law (without
regard to confl ict of law principals). This warranty
gives you specifi c legal rights, and you may also
have other rights which vary from state to state.
Horizon reserves the right to change or modify this
warranty at any time without notice.
WARRANTY SERVICES
Questions, Assistance, and Services
Your local hobby store and/or place of purchase
cannot provide warranty support or service. Once
assembly, setup or use of the Product has been
started, you must contact your local distributor or
Horizon directly. This will enable Horizon to better
answer your questions and service you in the event
that you may need any assistance. For questions
or assistance, please visit our website at www.
horizonhobby.com, submit a Product Support
Inquiry, or call the toll free telephone number
referenced in the Warranty and Service Contact
Information section to speak with a Product Support
representative.
Inspection or Services
If this Product needs to be inspected or serviced
and is compliant in the country you live and use the
Product in, please use the Horizon Online Service
Request submission process found on our website
or call Horizon to obtain a Return Merchandise
Authorization (RMA) number. Pack the Product
securely using a shipping carton. Please note
that original boxes may be included, but are not
designed to withstand the rigors of shipping without
additional protection. Ship via a carrier that provides
tracking and insurance for lost or damaged parcels,
as Horizon is not responsible for merchandise
until it arrives and is accepted at our facility. An
Online Service Request is available at http://www.
horizonhobby.com/content/_service-center_renderservice-center. If you do not have internet access,
please contact Horizon Product Support to obtain a
RMA number along with instructions for submitting
your product for service. When calling Horizon,
you will be asked to provide your complete name,
street address, email address and phone number
where you can be reached during business hours.
When sending product into Horizon, please include
your RMA number, a list of the included items, and
a brief summary of the problem. A copy of your
original sales receipt must be included for warranty
consideration. Be sure your name, address, and
RMA number are clearly written on the outside of
12